Download Print this page

Janome Artistic Suite V6 Manual

Download this manual

1. Open Artistic Suite V6 and connect the cutter to

the computer using the USB cable provided with

the cutter.

2. Set the blade at 6-8 depending on test results.

Note –refer to the manual and always test first.

3. When this screen appears, select "next".

4. When the screen appears for selecting the fabric,

choose "cotton" and then select "next". Note – no

fabric will be used this is just the background for

the crystal design.

Bling it ON!

Maddie Bushman Educational Coordinator

5. When the screen appears asking where the

artwork will be found, select "new graphic" and

then select "finish".

6. Select "tools" from the top toolbar, select "clipart

library" and then select "Insert clipart".

Need help?

Do you have a question about the Artistic Suite V6 and is the answer not in the manual?

Page 1 Bling it ON! Maddie Bushman Educational Coordinator 1. Open Artistic Suite V6 and connect the cutter to 5. When the screen appears asking where the the computer using the USB cable provided with artwork will be found, select “new graphic” and the cutter.
Page 2 7. Type “girl” in the tag bar and then select 9. While the design is still selected, select object “people22” and then select “insert”. properties, and then select “crystal fill”. 10. Adjust the “offset” to 2 and the “spacing” to 2, select desired crystal size (SS10), select “single line”...
Page 3 11. Using the roller wheel in the center of the mouse, zoom in to see if there is a red or yellow “x” in the center of any crystals. Note – this is an indication that the crystals are either too close or overlapping and must be moved or removed.
Page 4 16. To preview the crystal alignment, select “file”, 19. Place the carrier mat at the front of the cutter select “export” to “Crystal Cutters”. and press “enter” on the cutter to “load cutting mat”. Note – most designs will default to upper left hand corner of the mat.
Page 5 32. Place the tape with the crystals on the desired the iron on the garment surface. surface (garment, umbrella, totebag, purse etc.) 36. If possible turn over garment and press on the 33. Place a large enough pressing cloth on top of the wrong side for approximately 10-30 seconds.