Battery Installation 1.5V x 6 "D" (LR20) • Locate the battery compartment on the bottom of the toy. • Loosen the screws in the battery compartment door and remove the door. • Insert six, new “D” (LR20) alkaline batteries. Hint: We recommend alkaline batteries for longer battery life. •...
Battery Safety Information In exceptional circumstances, batteries may leak fluids that can cause a chemi- cal burn injury or ruin your product. To avoid battery leakage: • Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium).
Page 4
Setup Ball Chute Tabs Base Slots • Fit the tabs on the bottom of the ball chute into the slots into the opening on the base. • Turn the ball chute to lock in place. • Pull up on the ball chute to be sure it is secure.
Page 5
Swing at the golf ball while it "magically" • Slide the power/mode switch to fan mode . Place the golf balls into the chute. • Press the golf ball button on the base to release a ball. Watch the ball roll down the ramp and “magically”...
Page 7
Tee Action! Use tee mode during windy conditions, or to practice your swing. Power/Mode Switch Golf Ball Button • Fit the tee into the hole at the end of the base, as shown. • Slide the power/mode switch to tee mode . Place the golf balls into the chute. •...
Page 8
Storage • Store the plastic golf club and tee into the sockets in the back of the base. • When you are finished playing with this toy, slide the power/mode switch OFF .
FCC Statement (United States Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 10
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada. L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes: (1) il ne doit pas produire de brouillage et (2) l’utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif.