Haier HB21FWRSS Installation And User Manual page 17

It is recommended to leave storage space between the foods for good cold air
circulation. The temperatures in the refrigerator are slightly warmer near the top and
colder near the base. Suggestions for storage:
1. Eggs, butter, cheese etc.
2. Tins, cans, condiments etc.
3. Drinks and all kinds of bottled foods.
4. Pickled foods, drinks, cans etc.
5. Meat, poultry, fish and raw foods.
6. Flour foods, cans, dairy etc.
7. Cooked meats, sausage etc.
8. Fruits, vegetables, salads etc.
Changing the fresh food compartment light bulbs
The voltage and wattage of the fresh food compartment bulbs are: 220~240
Volt, 50 Hz - 25W. (Never use bulbs with power over 25W)
When changing the light bulbs:
Disconnect the appliance from the power supply.
1. Release the two tabs at the back of the light shield and remove the cover.
2. Turn the bulb in a counter-clockwise direction, then install a new bulb.
3. Install the light shield back in the tabs in the reverse order and snap back
into place.
Air curtain removal and installation (only for servicing if needed)
1. Remove the water filter.
2. Take off the fresh food light shield and unscrew the bulb.
3. Remove the screws of the air curtain frame, using a screw driver.
4. Take down the fresh food air curtain by using your hands to press down
on the air curtain with a little force.
Re-install the air curtain in reverse order.
To remove the full width pantry drawer:
• Remove the upper crisper compartments
• Remove the full width pantry door flap and lid
• Open the full width pantry drawer fully
• Grip the side runners of the drawer to ensure they remain in the fully extended
position, then push the drawer compartment back slightly to release it from the
locking mechanism on the runners (see image below).
• Grip the front and back of the drawer on the right hand side then lift and
manipulate the drawer slightly to release it from the runners.
• The drawer unit can then be removed.
Underside of
drawer unit
To re-install the full width pantry:
• Slide the drawer back onto the runners, ensuring the drawer locks back into place on the runner to prevent the drawer
from falling out.
Drawer runners
Drawer locking
mechanism