Table of Contents
Advertisement
1)
Remove any fuel in the hopper.
2)
Loosen set screw.
3)
Loosen wing nut.
4)
Adjust the fuel feed by pulling the rod back to increase the feed, and sliding it forward to decrease the feed.
5)
Tighten the set screw and the wing nut.
NOTE: Adjust fuel after the convection blower has been operating for 5 minutes. The flames should be 4" to 6" (100mm to
152mm) above the firepot after adjustment.
FEED ADJUSTMENT INSTRUCTIONS
Page 11
Hide quick links:
Advertisement
Table of Contents
