Advertisement
Quick Links
Advertisement
Summary of Contents for Polycom IPOWER 70
- Page 1 Installing the ™ iPower Room Camera...
- Page 2 Copyright © 2000-2002: Polycom, Inc. Polycom, Inc., 4750 Willow Road, Pleasanton, CA 94588 www.polycom.com Polycom and the Polycom logo are registered trademarks of Polycom, Inc. Concorde, Venue, and WorldCart are trademarks of PictureTel Corporation. Velcro is a registered trademark of Velcro USA, Inc.
-
Page 3: Table Of Contents
About this This booklet describes how to install the iPower 70 room camera. The iPower 70 is a pan-tilt-zoom (PTZ) camera that is used with a Booklet iPower collaboration system as a main or an auxiliary camera. This booklet contains information on:... - Page 4 INSTALLING THE IPOWER 70 ROOM CAMERA Before Installing Warning Before you begin this procedure, make sure you turn off your collaboration system’s power switch. To install this camera, you will need: The 8-pin camera cable (labeled with the icon on both cable collars) that came with your collaboration system, the WorldCart™, or the Premier Cart.
-
Page 5: Unpacking The Box
2. Carefully remove the camera from the packing material and place it on a flat surface. Caution When lifting the iPower 70 camera, always lift the unit by its base. Never lift the camera by its head. Note: Before you continue with the installation of the camera, please read the next section, “Important Note About... -
Page 6: Important Note
INSTALLING THE IPOWER 70 ROOM CAMERA Important Note The iPower 70 camera is designed to be controlled (moved) from the collaboration system wireless keypad, the keyboard, or the remote About Moving the control. Be sure that your system is turned on before you move the Camera camera. -
Page 7: Attaching The Camera To A Monitor
Attaching the Camera to a Monitor Attaching the Note: If you are installing a second monitor for a iPower 900 system, be sure to install the iPower 70 camera on the Camera to a NTSC or PAL monitor and not on the VGA monitor. If Monitor you are installing a second monitor for a Concorde•4500... -
Page 8: Connecting The Camera Cable
INSTALLING THE IPOWER 70 ROOM CAMERA Connecting the Camera Cable Caution Whenever you plug a cable into this camera, hold the camera by its base, not by the camera head. To connect the camera cable: 1. Plug the 8-pin camera cable... -
Page 9: Connecting An Additional Power Cable
Connecting an Additional Power Cable Connecting an Although the camera cable provides power to the iPower 70 camera, if you are using a camera cable longer than 32.8 feet (10 meters), you Additional Power must use an additional power cable for the camera. -
Page 10: Service And Support
INSTALLING THE IPOWER 70 ROOM CAMERA Service and For support or service, please contact your Polycom service provider or call Polycom Technical Support. You can find phone Support numbers for Technical Support in your area at the Polycom web site, www.polycom.com. Specifications Physical Specifications Dimensions: Length: 7.2 in.