Preparing For Operation; Unit Location - Sunbeam 2575 Owner's Manual

INTRODUCTION
Your Sunbeam 1800 Air Cleaner has been designed to
let you'enjoy a refreshing experience in clean air
living.
Airborne particles are removed from air passing
through the unit by the process of electrostatic precipi-
tation and an activated charcoal filter.
NOTE: This owner's manual should be read tho-
roughly before your air cleaner is operated.
Retain your owner's manual for future refer-
ence.
HOW THE SUNBEAM 1800 AIR
CLEANER WORKS
The air around you is filled with thousands of particles
of air pollution. Some of the pollutants (dust, smoke
and lint) are visible to the naked eye, but most of the
pollutants (pollen and bacteria, to name a few) are
microscopic in size.
Polluted air enters the air cleaner through the top front
grill of the air cleaner. (Figure 1) As shown in Figure 2,
the fan pulls in dirty air and the Pre-Filter (#I) traps
large particles (hair, lint, etc.). The smaller particles
(dust, smoke, pollen) in the dirty air receive a positive
electrical charge as they pass through the ionizer sec-
tion. (#2) The positively charged particles then enter
the collector (#3) which uses a series of alternately
charged aluminum plates to attract and retain the par-
ticles. It works like a powerful magnet and the particles
remain there through natural adhesion until removed
by the washing process. The air then passes through a
Charcoal Filter (#4) that helps remove household
odors. Finally, electronically cleaned air passes back
into the room through the bottom front grill. (Figure 1)
Figure
Figure 2
1
PREPARING FOR OPERATION
Before you operate your air cleaner you must:
1. Remove the polybag surrounding your air cleaner.
2. Remove the cabinet top by lifting up. Using the cell
handle, remove the Electronic Collecting Cell from
the cabinet and remove the plastic bag covering
the Charcoal Filter. Return the Charcoal Filter
back to its original position in the collector cell.
3. Install the Electronic Collecting Cell into the air
cleaner. (Metal aluminum Pre-Filter will face the
front grill.)
4. Replace the cabinet top.
Your air cleaner is now ready for operation.
UNIT LOCATION
Select the location for your air cleaner with an electri-
cal outlet nearby. An example of locating your air
cleaner is shown in Figure 3.
NOTE: DO NOT USE AN EXTENSION CORD TO
SUPPLY POWER TO YOUR AIR CLEANER.
Your Sunbeam air cleaner can be placed almost
anywhere as long as the air can freely circulate into
the top front grill and out of the bottom front grill.
(Figure 1)