Table of Contents
Advertisement
Section5: Maintenance
_
efore inspecting,cleaning or servicingthe machine, shut off engine, wait for movingparts to stop,dis-
connectsparkplug wire and movewire away from sparkplug.
Failure to follow these instructionscan result in seriouspersonal injuryor propertydamage.
STORAGE
OFF-SEASON STORAGE PROCEDURE
REPLACING WORNTINE SECTIONS
Thetines are excessively worn if tilling
takes much longer than before and soil is
not being mixed thoroughly enough.
1. Prop the machine forward so it rests
on the front of the tubular carrying
handle. The work surface should be flat
and firm.
2. Removethe ring lock pin (A, Figure 12)
from both sides of the unit. Removethe
old tine sections and replacethem with
new tine sections. Refer to Figure 12 and
the tine position shown in the Parts List
for tine positioning details. Insert the ring
lock pins through the rounded side of the
tine shafts and snap the ring over the
shaft (see DETAIL- Ring Lock Pin, Figure
10, in Section 4).
• Never store yourequipmentwhenthere
is fuel in the fuel tank.
• Never place your equipment near any
source of sparks or open flame (such
as from a hot water heater, a space
heater or clothesdryer).
Failure to comply can result in serious
personalinjury or propertydamage.
IMPORTANT:It is important to prevent
gum deposits from forming in essential
fuel system parts such as carburetor,fuel
filter, fuel hose, or tank during storage.
Also, experienceindicates that alcohol-
blended fuels (called gasohol or using
ethanol or methanol) canattract moisture
which leadsto separation and formation
of acids during storage. Acidic gas can
damagethe fuel system of an engine while
in storage.
• Protect the engine and perform recom-
mended engine maintenance by fol-
lowing the engine storage instructions
found in the separate Engine Owner's
Manual,
NOTE:Be sure to protect the fuel lines,
carburetor and fuel tank from gum de-
posits by removing the fuel or by
treating the fuel with a stabilizer. See
Engine Owner's Manual for more infor-
mation.
• Removetines. Cleanall soil and debris
from dust covers and tine shaft. Lubri-
cate tine shaft with light oil. Replace
tines.
• Cover engine and store equipment in a
dry, sheltered location.
TROUBLESHOOTING
Before performing any of the corrections in this Troubleshooting Chart, refer to the appropriate information contained in this Manual
and the Engine Owner's Manual for the correct safety precautions and servicing procedures. Contact your local authorized Engine
Service Dealerfor engine service. Contact your local authorized dealer for service problems with the machine.
£ngine does not start.
1. Spark plug wire disconnected.
2, Out of gas.
3. Stale gas,
4. Pdming/Choking
procedure not correct.
5. Dirty air filter(s),
6, Worn. corroded or broken spark plug.
7. On/Off Switch in OFF position.
1. Reconnect wire to spark plug.
2, Check fuel tank.
3. Drain old gas. Replace with fresh gas.
4. Refer to Pdming/Choking
procedure
and starting instructions in manual,
5. Clean or replace air filters,
6, Replace spark plug,
7. Move On/Off Switch to ON.
Engine runs poorly or
1, Fouled spark plug,
1, Remove, inspect, clean spark plug,
has low power under
2, Dirty air filter(s),
2, Clean or replace dirty air filters,
tilling conditions.
3. Stale gas,
3. Drain old fuel and replace with fresh fuel.
4. Carburetor malfunction/fuel
filter
4. See authorized engine service dealer.
clogged/ignition
malfunction/valves
stuck, etc.
Engine overheats,
1, Engine cooling system clogged,
1, Remove debris.
2, Carburetor out of adjustment,
2, See an authorized engine dealer,
Tines stop rotating,
1, Object wedged between tines and hood,
1, Remove wedged object,
2, Internal transmission
problem.
2, See an authorized engine dealer,
12
Advertisement
Table of Contents
