Table of Contents
Advertisement
Programming options
P r o g r a m m i n g
Specifying a device code
The simplest way to set up the MSR+ to control another product
is to enter the appropriate device code for the product. A complete
list of device codes for each of the supported products is given at
the back of this manual.
Entering a device code erases any learnt commands for that source
key.
To specify a device code
• Press the source key you want to use for the product; for
example, TAPE.
• Hold down 0 and Mute simultaneously for two seconds until the
indicator flashes twice and stays lit.
• Enter the appropriate device code on the numeric keypad.
For example, if your tape deck is a Revox enter 0664.
If you entered a valid device code the indicator will turn off and
your MSR+ is ready to control the other product. If you entered an
incorrect code, or pressed an invalid key, the indicator will flash six
times and programming is abandoned.
6
For some products more than one device code is listed. Try each
of the alternative device codes in turn until you find the one that
controls your product.
To reset the source key to control Meridian products enter the
device code 8888.
Auto-programming
This procedure lets you step through the library of remote controls
in the MSR+ until you find the one that switches your product to
standby. This is likely to be the correct one for your product.
To auto-program
• Make sure your other product is switched on and out of standby.
• Press the source key you want to use for the product; for example
TV.
• Hold down 0 and Mute simultaneously until the indicator flashes
twice and then stays lit.
Advertisement
Table of Contents
