Advertisement
UNASSEMBLED
PARTS
Key
Slope Sheet
(2) Keys
ASSEMBLY
Your new tractor has been assembled at the factory with the exception of those parts left unassembled for shipping
puposes.
When right or left hand is mentioned in this manual, it means
when you are in the operating position (seated behind the
steering wheel).
TO REMOVE TRACTOR FROM
CARTON
ADJUST
SEAT (See Fig. 2)
,,
Sit in seat.
•
Lift up adjustment lever (A) and slide seat until a com-
fortable position is reached which allows you to press
clutch/brake pedal all the way down.
•
Release lever to lock seat in position.
UNPACK
CARTON
*
Remove all accessible loose parts and parts cartons
from carton.
Cut along dashed lines on all four panels of carton.
Remove end panels and lay side panels flat.
Check for any additional loose parts or cartons and
remove.
CHECK
BATTERY
(See Fig. 1)
•
Lift seat pan to raised position.
If this battery is put into service after month and year
indicated on label (L) (label located between terminals)
charge battery for minimum of one hour at 6-10 amps.
(See "BATTERY" in the Maintenance
section of this
manual for charging instructions).
FIG. 1
FIG. 2
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate
instruction below to remove the
tractor from the skid.
,_L.WARNING: Before starting, read, understand and follow
all instructions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
TO ROLL TRACTOR
OFF SKID
(See Op=
eration
section
for location
and function
of
controls)
Raise attachment lift lever to its highest position.
Release parking brake by depressing
clutch/brake
pedal.
5
Advertisement
