Power Wheels C3491 Owner's Manual page 16

C3491pr-0920.qrk 10/30/03 4:01 PM Page 16
18
See
Inset
Front
Hole
• Turn the vehicle body over so that the bottom faces you.
• Insert one #8 x 3 / " screw through the front hole in the
4
vehicle body and into the windshield, as shown.
• Fit a small washer to two #8 x
screws with washers through the other holes in the vehicle
body and into the windshield, as shown.
• Tighten the screws.
19
Front
Axle
Curve TOWARD You
• Turn the steering linkage so
that the inside (grooved side)
is facing up and the curve is
toward you.
• Position each front axle so
that the short end is facing up.
• Insert the short end of the
front axles up through the
ends of the steering linkage,
as shown.
See
Inset
Bottom View
3 / " screws. Insert these
4
Steering Linkage
See
Inset
Steering Linkage
Steering
Linkage
Short End of
Front Axle
Long End of
Front Axle
Assembly
20
B Marking
Large
Washer
Front
Axle
B Marking
• Slide a large washer onto the
short end of each front axle.
• Position the steering linkage
cover over the steering linkage.
Make sure the A and B
markings in the steering linkage
cover match the A and B
markings in the steering linkage. Fit the steering linkage
cover onto the front axles.
Note: The steering linkage curve should still face you.
Front
21
Axle
• Fit a .437 white cap nut onto the end of a front axle.
• Tap the cap nut with a hammer to secure it to the end of the
front axle.
• Repeat this procedure to fasten another .437 white cap nut
to the other front axle.
16
A Marking
See
Steering
Inset
Linkage
Cover
A Marking
Steering
Linkage
Curve
TOWARD
You
Large
Washer
Front
Axle
Steering
Linkage
Cover
Large
Washer
A Marking
Cap
Nut
Front
Axle