Troubleshooting; Accessories - Porter-Cable FC350A Instruction Manual

_Disconnect toolfrom airsupply before performing anyService
Procedure.
SYMPTOM PROBLEMS SOLUTIONS
1. Air leak near top of Loose screws. Tighten screws.
tool or in trigger area. Worn or damaged Install Overhaul Kit.
o-rings or seals.
2. Tool does nothing or Inadequate air supply. Verify adequate air supply.
operates sluggishly. Inadequate lubrication. Put 5 or 6 drops of oil into air inlet.
Worn or damaged Install Overhaul Kit.
o-rings or seals.
3. Air leak near bottom Loose screws. Tighten screws.
of tool. Worn or damaged Install Overhaul Kit.
o-rings or bumper.
4. Tool jams frequently. Incorrect fasteners. Verify approved fasteners of
correct size.
Replace w/undamaged fasteners.
Tighten screws.
Damaged fasteners.
Magazine or nose
screws moose.
Magazine is dirty. Clean magazine.
Driver is worn or damaged. Install "DRIVER" Maintenance Kit.
5. Other. Contact a Porter-Cable
Service Facility.
A complete line of accessories is available from your Porter-Cable • Delta
Supplier, Porter-Cable • Delta Factory Service Centers, and Porter-Cable
Authorized Service Stations. Please visit our Web Site www.porter-cable.com
for a catalog or for the name of your nearest supplier.
_Since accessories, other than those offered by Porter-
Cable • Delta, have not been tested with this product, use of such
accessories could be hazardous. For safest _, only Porter-
Cable o Delta recommended accessories should be used with this
product.
13