Pentax K-X Operating Manual page 84

iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiii_
iiii iiiiiiiiiiiiii
iiiiiiiiiiiiiiiii_iiiiii!
iiiiiiiiiiiiiiii_!_i!i!i'i
iiiiiiiiiiiiiii_i!iiii
iiiiiiiiiiiiiiiii_iliiiii_i!
iiiiiiiiiiiiiiiiii :ii:ii:i!:!il
iiiiiiiiiiiiiii !i!ili!i!!i!iii!i i
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iHHHHHHiiii
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiii
iHHHHHHiiii
You can set the image finishing tone before shooting when the capture
mode is set to P (Program), Sv (Sensitivity Priority), Tv (Shutter Priority),
Av (Aperture Priority) or M (Manual).
Select from the following seven modes for Image Tone: Bright (default
setting), Natural, Portrait, Landscape, Vibrant, Muted and Monochrome.
You can adjust the following items for Image Tone.
Item I Settings
Saturation .1 Sets the color saturation. (Available settings: -4 to +4)
Hue .1 Sets the color. (Available settings: -4 to +4)
High/Low Key Adj Changes the brightness of the image. (Available settings: -4
to +4)
Contrast Sets the image contrast. (Available settings: -4 to +4)
Sharpness, 2 Sets the sharpness of the image outlines. (Available settings:
-4 to +4)
Changes the contrast to appear as if a B&W color filter was
Filter Effect .3 used. Sets the filter color. (Available settings: [None],
[Green], [Yellow], [Orange], [Red], [Magenta], [Blue], [Cyan],
[Infrared Filter])
Sets the level for cold tone adjustment (- direction) and warm
T°ning*3 tone adjustment (+ direction). (Available settings: -4 to +4)
"1 This can be set when any mode other than [Monochrome] is selected.
*2 You can also change the setting to [Fine Sharpness], which makes image outlines even
thinner and sharper.
*3 This can be set when [Monochrome] is selected.
Custom Image cannot be used when Cross Processing is set.
1
Press the
INFO
button in the status screen.
The control panel appears.
Press the INFO button when the status screen is not displayed.