Table of Contents
Advertisement
NOTE:
If the control handle is disassembled
from the upper handle for any reason, assemble the control
handle by inserting the ends into the holes on each side of the upper handle. The hole in the control handle
must be on the left side of the upper handle, and control handle must touch the upper handle when engaged
(squeezed against the upper handle).
• Remove the truss machine screw and hex lock nut from the middle of the control box using a phillips
screwdriver.
Place your finger over the hex lock nut to hold it inside the control box so you can unscrew
the truss machine screw.
• Make certain the blade control handle is on top of the upper handle.
• Route the control box (with cable attached) under the lower handle.
• Holding the control box near the left side of the upper handle (control box must be inside the handle),
hook the "Z" end of the brake cable into the control handle from the outside to the inside. See Figure 6
and Figure 7.
End of Control Handle
X
/
Hex Lock Nut
Truss Machine Screw
\
Figure 7
• Place the control box on the upper handle just below (touching) the end of the control handle as shown
in Figure 7. Secure with hardware removed in step one by placing hex lock nut into the indent on the
inside of the control box. Screw the truss machine screw into the hex lock nut.
SECURING
THE CABLE
(Hardware D)
Secure the cable to the left side of the handle as follows.
_,
WARNING:
When attaching the control cable, the cable must be routed to avoid contact with all
sharp edges and hot surfaces to prevent damage to the cable.
Post on '_
Tie
Figure 8
• Insert posts on cable ties into holes provided on the handle. There is one on the upper handle and two
on the lower handle.
See Figure 8A.
• Secure the cable with the cable ties. Trim excess ends of cable ties. See Figure 8B.
10
Advertisement
Table of Contents
