Advertisement
<
our home may use a single (75
hm) cable, or have a Converter
Box installation. Connect the thread-
ed end of the cable signal to the TV's
antenna plug and screw it down.
>
If your Cable 'IV signal is a single
round cable (75 ohm) then you're ready
to connect to the TV.
If you have a Cable TV Converter
Box: Connect the Cable TV signal to the
Cable Signal IN(put) plug on the
Converter.
_Z_
Connect the Cable TV cable to
the ANTENNA/CABLE
plug on the
TV. If you have a Cable Converter
Box: Connect the Converter to the
ANTENNA/CABLE
plug on the TV.
O
Cable TV Company
Cable TV Signal Input
Round Cable
75_ Ohm
NOTE: The connecting cable for
the Converter is supplied from
the Cab e TV Company.
Cable TV Converter
Box Connection
Back of TV
ust connected (see
7.)
To select only the
channel numbers on
your Cable system
see "Auto Install"
(page 7). If you use a
Cable Converter box,
set the TV to the
same channel as the
converter's CH 3/4
switch (on the rear of
the converter.)
hrT_, basic Antenna,
or Cable
to VCR to TV connection
is shown to theeright. For more
information
on other hookups
refer to your accessory
VCR and
Cable Oonverter
Owner's Manual
for details.
<1_
Connect your Antenna or Cable
] TV signal to the IN FROM
. ANT(enna) plug on the VCR.
_2,_
Connect the OUT TO TV plug
on the VCR to the ANTENNA plug
on the TV (connecting cable supplied
with the VCR).
_5_
Refer to the Owner's Manual
included with your VCR for other
possible connections and TV/VCR
operating details.
r VHF/UHF
lltcana
x,xCable TV signal
VCR
Back of TV
Round Cable
7512 Supplied with VCR
Advertisement
