Channel Memory - Magnavox VR9720AT01 Operating Instructions Manual

CHANNEL MEMORY
REMOTE CONTROL
Channel Memory can be used to assign channels to the CHANNEL
UP/DOWN Keys for channel scanning. By following the steps below
you can set the 155 channel memory into _CATV" to receive Cable
channels or from Cable band back to "TV"; the TV band was initially
set at the factory. The AUTO SET feature can be used in either band CHANNEL
and the VCR itself will selectively assign channels for scanning to MEMORY
include just those receivable in your area. Any time a channel is BUTTON
selected for viewing you may drop or assign it for scanning with the
ADD/DELETE Button. For available channels see the chart at the ADD/DELETE
bottom of the next page. BUTTON
A
AUTOMATIC SETTING
(PREPARATIONS on page 1 must be completed.)
C_3C:3_
SELECT CHANNEL MEMORY START AUTO SET
Hold the CHANNEL
MEMORY Button In and
press key (_).
CHANNEL MEMORY GUIDE
CH 02(ADD) TV
ANTENNA SYSTEM
_---4.,SHIFT TV _ CATV
5..NO CHANGE
OR PUSH KEY 4 OH 5
EXIT..CH MEMORY & 1
_4..SHIFT CATV + TV)
SELECT ANTENNA SYSTEM
(A) TOCHANGETHE
CURRENT BAND
Press key (_) to change
the band as follows.
from "TV" _ to "CAW"
or
from "CAW" -- to "TV"
Changing bands removes previous
channel assignments and assigns
all channels in the new band to the
CHANNEL UP/DOWN Keys.
................. OR .................
(B)
TO KEEP THE CURRENT
BAND
Press key(_).
This selects "NO CHANGE".
Use when the band selected already
matches your Antenna System.
Press key(_).
AUTO SET GUIDE
CH 02(ADD) TV
AUTO SET
PUSH KEY 4
FOR AUTO SET
OR
EXIT..CH MEMORY & 1 /
J
This starts Auto Set Channel Scan
in the selectedband.
02
AUTO SET
PROCEEDING
After Auto Set, the lowest numbered
channel assigned to the CHANNEL
UP/DOWN Keys will appear on
screen,
-NUMERIC
KEYS
-CHANNEL
UP_OWN
KEYS
• Hold the CHANNEL MEMORY Button in and press key (_) for release of CHANNEL MEMORY mode while
setting the CHANNEL MEMORY.
-11-