Installation Instructions; Refrigerator - GE Profile Owner's Manual And Installation Instructions

Installation
Instructions
Refrigerator
GE and GE Profild _ models
Questions? Call 800.GE.CARES (800.432.2737) or visit our Website at: GEAppliances.com
In Canada, call 1.800.561.3344 or visit our Website at: www.GEAppliances.ca
BEFORE YOU BEGIN
Read these instructions completely and carefully,
Built-in style models (model PYE,CYE,and PWE)are top
heavy, especially with any doors open, These models
must be secured with the anti-tip floor bracket to prevent
tipping forward, which could result in death or serious
injury, Read and follow the entire installation instructions
for installing the anti-tip floor bracket packed with your
refrigerator,
• IMPORTANT - Observe
a,
g overning
codes and
ordinances, Savethese instructions for local inspector's use,
• Note to Installer- Be sure to leave these instructions with
the Consumer,
• Note to Consumer - Keep these instructions for future
reference,
• Skilllevel- Installation of this appliance requires basic
mechanical skills,
• Completion time - Refrigerator Installation can vary
Water Line Installation 30 minutes
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not covered
under the Warranty,
PREPARATION
MOVING THE REFRIGERATOR INDOORS
If the refrigerator will not fit through a doorway,
the refrigerator door and freezer drawer can be removed,
• To remove the refrigerator door, see the Installing
the Refrigerator section,
• To remove the freezer drawer, see the Removing
the Freezer Drawer section,
WATER SUPPLY TO THE ICE MAKER AND DISPENSER
If the refrigerator has an ice maker, it will have to be
connected to a cold water line, AGE water supply kit
(containing tubing, shutoff valve, fittings and instructions)
is available at extra cost from your dealer, by visiting
our website at GEAppliances, com (in Canada at www,
GEAppliances, ca)or from Parts and Accessories,800,626,2002
(in Canada 1,800,661,1616),
TOOLS YOU MAY NEED
Adjustable Wrench
3/_" Socket Ratchet/Driver
o@
114" Outer Diameter
Compression Nut
and Ferrule (sleeve)
Phillips-Head Screwdriver
1/8", 3/32", 114"& 5/32"
Allen Wrenches
Flat-Head Screwdriver
118" Drill Bit and
Electric or Hand Drill
Pencil
Tape Measure
1/4" Nut Driver
5/16" Nut Driver
Pliers
Level
Torx T20, T25
21