Knoll VC105pm Installation Instructions

Operation: Knoll Systems volume controls are very easy to use. The
VC105pm has a total of 12 different volume settings including fully off.
To increase the volume (in this room only), turn the volume control
knob clockwise. To lower the volume, turn the volume control knob
counterclockwise.
To set the correct amplifier or receiver volume setting, we
suggest that you turn the VC105pm volume control in one room to
maximum (clockwise). Adjust the amplifier or receiver volume to the
loudest comfortable setting you will use and no further or louder. This
way the VC105pm volume control has the most usable settings. If the
amp volume control was set louder, the volume control would have to
be turned down to be back at a comfortable level allowing less overall
volume positions available.
Warranty
Knoll Systems warrants the VC105pm sold in the USA and Canada by
authorized Knoll dealers to be free of defects in materials and workmanship.
This warranty extends for three full years from the date of purchase by the
original consumer. Any products returned to Knoll Systems and found to be
defective by Knoll Systems within the warranty period will be repaired or
replaced at Knoll Systems option, at no charge. Knoll Systems will not be
responsible for the actual cost of installation or removal of the product, nor for
any incidental or consequential damages. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above
limitation may not apply to you. This warranty gives you specific legal rights.
You may have additional legal rights that vary from state-to-state.
Specifications
Peak RMS Power Rating 105 watts per channel
Continuous RMS Power
Frequency Response
Mounting Depth
Electrical Junction Box
Speaker Impedance
Connection
Knoll Systems
145 Tyee Drive Point Roberts, WA 98281 USA
14-7163 Vantage Way, Delta BC V4G 1N1 Canada
Tel: (604) 940-1689, fax (855) 734-3363
www.knollsystems.com
55 watts per channel
0 to 500,000 Hz
1.85" (47mm)
Fits single gang
4-16 ohms (single or multiple
speakers)
Detachable screw terminals
VC105pm
Impedance Matching Volume Control
Installation Instructions v1.0
Warning: To be installed and/or used in accordance with appropriate
electrical codes and regulations.
Caution: Do not install these keypads in an electrical junction box
with 110V or higher unless an approved barrier separates the high and
low voltage sections.
Description: The Knoll Systems VC105pm is a twelve-position in-wall
mountable stereo speaker volume control with POWERMATCH™ fully
automatic impedance matching capability. From one to six pairs of
speakers can be safely driven from one stereo amplifier using an equal
number of VC105pm's. Separate impedance matching components are
not required.
The Knoll Systems WT6 one stereo input to six stereo output
connection strip is available to organize the wiring of larger systems.
The VC105pm is one of the smallest size volume control ever made by
Knoll Systems, so it fits almost everywhere. A slider switch version is
available, model VS105pm.
 Small size high power volume control. Only 1.85"
deep. Fits almost anywhere.
 105 RMS watts per channel.
 Full frequency response 0 Hz to 500,000 +/- 1 dB.
 Best sound quality possible because autoformers
are not used.
 Single gang decorator style.
 Detachable screw terminals for 12-24 gauge wire.
 V-pad design doesn't burn off excessive heat like
L-pads.