Knoll UBWX-HDMI Installation Instructions

UBWX-HDMI Balun Specifications:
Dimensions:
UBWX-HDMI (in-wall Decora™ version): 4.1"h x 1.4" w x 1-1/8"d.
Inputs and Outputs:
Send Unit: One HDMI input jack, two RJ-45 out-jacks, one 2.1 mm DC
power input, one mono 3.5 mm infrared emitter connector.
Receive Unit: One HDMI output jack, two RJ-45 in-jacks, one 2.1 mm DC
power input, one DC power terminal (two position), one stereo 3.5 mm
infrared receiver connector.
Power:
Included power supply 5 VDC 1 amp (center positive) connected to the
receive unit.
Temperature Range:
-5 to +35 C (+20 to +95 F)
Warranty
Knoll Systems warrants its products sold in the USA and Canada by authorized Knoll dealers to be
free of defects in materials and workmanship. This warranty extends for three full years from the
date of purchase by the original consumer. Any products returned to Knoll Systems and found to be
defective by Knoll Systems within the warranty period will be repaired or replaced at Knoll Systems
option, at no charge. Knoll Systems will not be responsible for the actual cost of installation or
removal of the product, nor for any incidental or consequential damages. Some states do not allow
the exclusion or limitation of incidental or consequential damages, so the above limitation may not
apply to you. This warranty gives you specific legal rights. You may have additional legal rights that
vary from state to state.
Knoll HDMI baluns pass HDCP and digital audio signals without manipulating them in
any way.
Knoll Systems
www.knollsystems.com
145 Tyee Drive Point Roberts, WA 98281
14-7163 Vantage Way, Delta BC V4G 1N1
Tel. (604) 940-1689, fax (855) 734-3363
Made in China Knoll Systems All Rights Reserved
UBWX-HDMI
Installation Instructions v1.0
Warning: To be installed and/or used in accordance with appropriate electrical
codes and regulations. If you are unsure about any part of these instructions,
consult a qualified electrician.
Caution: Do not install this product in an electrical junction box with 110V or
higher unless an approved barrier separates the high and low voltage sections.
Introduction: Thank you for purchasing a Knoll active balun system. This system
is specifically designed to send 1080p HDMI and infrared signals safely down
two cat 5e or cat 6 wires up to 100 feet (30 meters) without encountering signal
degradation problems (resolutions lower than 1080p will transmit to further
distances).
To install wires inside walls, in most jurisdictions require wires to be minimum
class 2 rated for safety. Almost all conventional HDMI wires are unrated so they
cannot legally be installed inside walls. The most cost effective method to install
a legal HDMI inwall run is to use cat 5e wire and Knoll HDMI baluns.
Features:

White color Decora™ style HDMI transmit and receive modules.

Will safely send 480i/p, 576i/p, 720p and 1080i/p.

Equalization, level correction as well as clock and data recovery
retiming are fully automatic.

Infrared receiver and emitter included.

5 VDC power supply is included