PS Audio PerfectWave Quick Start Manual

Hide thumbs Also See for PerfectWave:

Dear PS Audio Customer,

Thank you for purchasing a PS Audio PerfectWave Network Bridge.

We understand that you have a choice in determining which components to

buy and we greatly appreciate that you have included PS Audio products in

your system.

This packing carton contains several items and we ask that you carefully

check to be sure all the items are included.

Inside the box:

PerfectWave Media Bridge

SD Card With PWD firmware

Anti-static Strap Disposable Wrist Band

w/ alligator clip

Quick Start Guide (This Book)

If you are missing any of the above items, experience any problems with the

product or simply have questions, please call us directly at 720-406-8946 or

email us at customerservice@psaudio.com.

There is an online version of this guide available on YouTube at:

http://www.youtube.com/watch?v=mKLq8aFHekk

Happy listening!

Sincerely,

The Crew at PS Audio

Packed By:

Rev A

Quick Start Guide

12-057-01-1

12-054-99-1

99-000-01-2

15-057-01-1

Introduction I

Table of Contents

Do you have a question about the PerfectWave and is the answer not in the manual?

Page 1: Quick Start Guide
Thank you for purchasing a PS Audio PerfectWave Network Bridge. We understand that you have a choice in determining which components to buy and we greatly appreciate that you have included PS Audio products in your system. This packing carton contains several items and we ask that you carefully check to be sure all the items are included.
Page 2 Turn off the DAC using the power switch on the rear of the unit Using a Phillips screwdriver (#1 tip), remove the two screws holding the blank panel over the expansion slot on the rear of the PerfectWave DAC. Retain the screws to hold the Bridge card in place later.
Page 3 When the blinking stops you will see the initialize screen on display. The DAC should power up normally. It is now updated with the software necessary to run the Bridge. Introduction III PS Audio International, Inc. All rights reserved...
Page 4 Bridge Installation Connect an Ethernet cable from a network switch, router, or hub to the Ethernet port on the Bridge card back panel. Check to see if the Bridge requires a firmware update. To do this you must be connected to the Internet. Once connected, go to the Input Select screen on the PWD’s touch screen.