Declaration Of Conformity - Hitachi HSB40B16 Owner's Manual

Important Safety Instructions
CANADIAN RSS NOTICE
This device complies with Industry Canada RSS-210.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie
Canada applicables aux appareils radio RSS-210.
L'exploitation est autorisée aux deux conditions
suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage
radio électrique subi, si le brouillage est susceptible d'en
compromettre le fonctionnement.
This device meets the exemption from the routine
evaluation limits in section 2.5 of RSS-102 and
compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance.
Le dispositif rencontre l'exemption des limites courantes
d'évaluation dans la section 2.5 de RSS-102 et la
confirmité á l'exposition de RSS-102 rf, utilisateurs peut
obtenir l'information Canadienne sur l'exposition et la
conformité de rf.
U.S. FEDERAL COMMUNICATIONS
COMMISSION NOTICE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment
and receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
MODIFICATIONS
FCC regulations state that any changes or modifications
made to this device that are not expressly approved by
Hitachi America, Ltd. may void the user's authority to
operate the equipment .
CABLES
Connections to this device must be made with shielded
cables with metallic RFI/EMI connector hoods to maintain
compliance with FCC Rules and Regulations.
Any cables or power cords or power adapters supplied
with the system must be replaced with identical parts in
order to assure compliance.
You may order those replacement parts from Hitachi.

DECLARATION OF CONFORMITY

This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
For questions regarding this declaration, contact:
Hitachi America, Ltd.
900 Hitachi Way
Chula Vista, CA. 91914
800.448.2244 (800.HITACHI)
ATTN: Customer Relations
LEAD NOTICE
This product contains lead. Dispose of this product in
accordance with applicable environmental laws. For
product recycling and disposal information, contact your
local government agency or
California), the Electronic Industries Alliance at
www.eiae.org (in the U.S.) or the Electronic Product
Stewardship Canada at www.epsc.ca. (in Canada). For
more information, call 800.HITACHI.
This unit meets
ENERGY STAR for A/V
program requirements.
If no audio input signal has been detected for 30
minutes, this unit automatically powers down to save
you energy.
Press the Power button on the remote control or top
panel to wake the unit.
www.erecycle.org (in
3