Introduction; Safety & General Use Information - Grace Digital GDI-USBM10 User Manual

INTRODUCTION

The Business Audio System (GDI-USBM10) is an on hold audio system for use with a PBX or a
Key Phone system. The system is designed for ease of use by simply plugging the unit into your
existing phone system with a single audio cord connection. Play from audio tracks made
available on the USB flash drive.
You may use the pre-recorded audio on the USB drive or you may record your own audio tracks
on your PC computer using the Grace Music Master Recording Software included with you unit.
Once completed and saved to your computer, download the desired recordings to the USB
drive for use on your Business Audio System.
WARNING: Please carefully read the User Guide for operational & safety instructions now.
Keep the User's Guide in a secure place for future reference.
SAFETY & GENERAL USE INFORMATION
ADVISORY: This product is intended for North American markets. The unit is in compliance
with the essential requirements and other relevant provisions of Directive 199/5/EC
FCC INFORMATION Pursuant to Part 15 of the FCC Rules, this equipment has been tested and
found to comply with the limits for a Class B digital device. These limits are designed to
produce reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. The unit may malfunction when there is radio interference on the power line/signal
line. The unit will revert to normal operation when the interference stops. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment on and off, the user is encouraged to try to correct the interference by
one or more of the following measures:
 Reorient or relocate the receiving antenna
 Increase the separation between the equipment and receiver
 Connect the equipment in to an outlet on a circuit different from that to which the
receiver is connected
 Consult the dealer or an experienced radio/TV/electronics technician for assistance.
CAUTION: To comply with the limits, Federal Communication Commission (FCC) warns any
changes or modification not expressly approved by the party responsible for compliance may
void the user's authority to use and/or operate this equipment. Any modification or improper
use of the unit may void the limited manufacturer's warranty.
2