Table of Contents
Advertisement
Preparing your projector
Checking accessories
The following accessories are provided with this projector. Check to be sure that all of the
accessories are packed in the package.
•
Power cord
•
Remote control R03 with batteries (2 x AAA)
•
Lens cap
•
This User manual
Inserting the batteries into the remote control
•
Remove the rear lid of the remote control.
•
Check the polarity (+), (-) of the batteries, and set them correctly, inserting their (-) side
first. If the battery is inserted from the (+) side first, inserting the (-) side is difficult
because the coil spring end hits on the battery side. If the battery is forced to insert in
this way, the outer label of the battery may get ripped and it may cause a short-circuit
and heat
•
Attach the rear lid.
Important:
•
Use two size-AAA batteries (ROU
•
Replace the two batteries with new ones when the remote control is slow to operate.
Caution:
•
If the batteries are treated incorrectly, they may cause fire or other contamination due to
leakage of the liquid, heating, or they may burst. (Read the cautions indicated on the
battery, too.)
•
Do not use a new battery with an old one.
•
Load batteries in the correct position.
•
Do not heat, take apart, or throw batteries into fire.
•
Do not try to recharge batteries. Do not use rechargeable batteries.
•
If the solution of batteries comes in contact with your skin or clothes, rinse with water. If
the solution comes in contact with your eyes, rinse them with water and then consult
your doctor.
7
Advertisement
Table of Contents
