Getting Started - PS Audio Quintet and Duet Power Center Owner's Reference Manual

®
Once your new Power Center is
Location
unpacked, you'll need to fi nd a
convenient place to set it.
There are several ways to mount
Mounting
the Power Center: on the fl oor, on
a shelf, or in a rack. If you mount it
on the fl oor, it can either lay fl at on
its bottom, or be placed at an angle
between the fl oor and the wall.
Note the Power Center is shaped in
a truncated triangle on the bottom
to facilitate placing it in an angled
position.
If your equipment is located a long
distance from the Power Center, it
is preferable to use a long, heavy
gauge shielded power cable between the wall AC receptacle and the Power Center, rather than long
individual power cables between the equipment and the Power Center.
Isolation The Power Center can benefi t from aftermarket isolation devices such as cones, spikes and
Sorbothane pads.
Once you have chosen the location for the Power Center you can use the supplied AC power cord
to connect it to the AC wall receptacle or you can use an aftermarket power cord and receptacle.
We strongly recommend the use of a PS Audio xStream Power™ AC cable and a PS Power Port™
Power Cables
AC receptacle, or Soloist AC receptacle to feed the Power Center electricity. While the supplied
power cable is adequate for the task, it is not going to provide the best performance. Choosing any
xStream Power cable will make a signifi cant performance improvement over the stock power cable.
Conditioners We recommend the use of a PS Soloist in-wall conditioner to feed this device. We do not
recommend connecting any other power conditioning product before the Quintet or Duet.
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.pspower.com

Getting Started

©2007 PS Audio International Inc. All rights reserved.
Owner's Reference Quintet and Duet Power Center
Getting Started 1