Table of Contents
Advertisement
StartingEngine
•
Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug is
fastened securely over the metal tip on the spark
plug.
•
Prime engine as instructed in the separate engine
manual packed with your unit.
•
Your lawn mower may be equipped with a constant
speed throttle, which is set at full throttle for best
performance.
•
Stand behind the mower and squeeze the blade
control handle against the upper handle.
•
Grasp recoil starter handle and pull rope out slowly
until engine reaches the start of compression cycle
(rope will pull slightly harder at this point). Let the
rope rewind slowly. Pull rope with a rapid,
continuous, full arm stroke. Keeping a firm grip on
the starter handle, let the rope return to the starter
slowly.
NOTE: See your engine manual packed with your un#
for more detailed instructions.
Stopping Engine
•
Release blade control handle to stop the engine
and the blade.
•
Disconnect spark plug wire and ground against the
engine.
UsingYourLawn Mower
Be sure the lawn is clear of stones, sticks, wire, or other
objects which could damage the lawn mower or the
engine. Such objects could be accidently thrown by the
mower in any direction and cause serious personal
injury to the operator and others.
For best results, do not cut wet grass because it tends
to stick to the underside of the mower, preventing
proper discharge of grass clippings, and could cause
you to slip and fall. New grass, thick grass, or wet grass
may require a narrower cut.
For a healthier lawn, never cut off more than one-third
of the total length of the grass. Your lawn should be cut
in the fall as long as there is growth. This mower is
designed to be operated at full throttle to give you the
best cut and do the most effective job of mowing or
mulching.
WARNING:
If you strike a foreign
object,
stop the engine.
Remove wire from the
spark plug, thoroughly inspect the mower
for any damage, and repair the damage
before
restarting
and
operating
the
mower. Extensive vibration of the mower
during
operation
is
an
indication
of
damage.
The unit should
be promptly
inspected and repaired.
Mulching
For effective mulching, do not cut wet grass because it
tends to stick to the underside of the deck, preventing
proper mulching of grass clippings. New or thick grass
may require a narrower cut. The ground speed should
be adjusted to the condition of the lawn. If mowing has
been delayed and the grass has been allowed to grow
in excess of 4", mulching is not recommended. Mow
using the side discharge to reduce the grass height to 3
1/4" maximum before mulching.
MakingAdjustments
,_
WARNING:
Always stop engine,
discon-
nect
spark
plug,
and
ground
against
engine before performing adjustments.
Cutting HeightAdjustment
Each wheel has a height adjustment lever which
provides cutting height adjustment. When the
adjustment lever is moved from one location to another
the height of cut will be changed. Simply depress the
lever towards wheel and move lever assembly to
desired position. See Figure 8.
IMPORTANT:All wheels must be placed in the same
relative position. For rough or uneven lawns, move the
height adjustment lever to a higher position. This will
help stop scalping of the grass.
Height
Adjustment Levers
Figure 8
11
Advertisement
Table of Contents
