Advertisement
Shredder head
Safety lock
Unlocked (green)
Locked (red)
Bin
Pivoting head
Safety flap
Easy emptying
(Cross-Cut models only)
CAPABILITIES
Will shred: Paper, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, paper clips, laminates or plastic other than
noted above
Paper shred size:
Strip-Cut ............................................................................ 1/4" (6.3mm)
Confetti-Cut ..................................................... 5/32" x 2" (3.9 x 50mm)
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Always unplug or set
safety lock when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc.– away from shredder openings. If object enters top
opening, switch to Reverse (R) to back out object.
• Avoid touching exposed blades under Confetti-Cut shredder head.
2
ENGLISH
Models P-40/P-45C
Paper/credit card entry
See safety instructions below
Sheet capacity gauge
Waste opening
Handle
Control switch
Auto-On (I)
Off (O)
Reverse (R)
To set lock, push
down and slide
Maximum:
Sheets per pass (Strip-Cut P-40) ............................................................ 8*
Sheets per pass (Confetti-Cut P-45C) ..................................................... 6*
Cards per pass ........................................................................................1
Paper width .............................................................................9"/229mm
Continuous operation ..............................................................5-7 minutes
* 20lb., 8.5"x11" paper at 120v, 60Hz, 2.0 Amps; heavier paper, humidity or
other than rated voltage may reduce capacity.
• Never use aerosol, petroleum-based or other flammable products
on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not open shredder head.
Do not place near or over heat or water source.
• 6 sheets per pass to avoid jams
• The socket-outlet shall be installed near the quipment and shall be
easily accessible.
OPERATION
Insert waste bag (Fellowes #36052) for easy disposal.
PAPER
Continuous operation:
Check paper amount
5-7 minute maximum
NOTE: Shredder runs briefly
Set to Off (O)
after each pass to clear entry.
CARD
and plug in
Continuous operation beyond 5-7
minutes will trigger 20-minute
cool down period.
Set to Auto-On (I)
Safety Lock prevents accidental operation.
To set, wait for shredding to stop, push black button down and slide until you see red.
To unlock push black button down and slide until you see green. For greater safety, always unplug shredder after use.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or
all of the below procedures.
Set to Reverse
Alternate slowly back and forth
Set to Off (O)
(R) for 2-3
and unplug
seconds
MAINTENANCE
Follow oiling procedure below and repeat twice.
Confetti-Cut and Strip-Cut:
Run regularly in reverse for
one minute
Confetti-Cut only:
Lubricate when bin is full, or
Set to Off (O)
*Apply oil
immediately, if:
across entry
• Capacity decreases
• Motor sounds different, or
Shredder stops running
*Only use a non-aerosol vegetable oil in long nozzle container
WARRANTY
LIMITED WARRANTY Fellowes, Inc. ("Fellowes") warrants the cutting blades of the
machine to be free from defects in material and workmanship for 3 years from
the date of purchase by the original consumer. Fellowes warrants all other parts
of the machine to be free of defects in material and workmanship for 1 year from
the date of purchase by the original consumer. If any part is found to be defective
during the warranty period, your sole and exclusive remedy will be repair or
replacement, at Fellowes' option and expense, of the defective part.
This warranty does not apply in cases of abuse, mishandling, or unauthorized
repair. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY OR
Set to Auto-On (I)
Feed into paper entry
and release
Hold card at edge
Feed into center of entry
and release
Shredder doesn't start:
Make sure head is on basket correctly
Wait 20 minutes for motor to cool down
Remove and empty basket
Make sure safety lock is in unlock
Remove shredder head
Set to
(green) position
and cut hanging shreds.
Reverse (R)
Replace shredder head.
Plug in.
Set to Auto-On (I)
Shred one sheet
Set to Reverse (R)
for 2-3 seconds
FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE
APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be
liable for any consequential or incidental damages attributable to this product.
This warranty gives you specific legal rights. The duration, terms, and conditions of
this warranty are valid worldwide, except where different limitations, restrictions,
or conditions may be required by local law.
For more details or to obtain service under this warranty, please contact us or
your dealer.
Set to Off (O)
and unplug
3
Advertisement
