Fellowes POWERSHRED 60Cs Instructions page 3

BASIC SHREDDING OPERATION
PAPER/CARD
1
Continuous operation:
Up to 6 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Plug in and put
Continuous operation beyond
disconnect power
6-minutes will trigger
switch in ON ( – ) position
30-minute cool down period.
ADVANCED PRODUCT FEATURES
SAFESENSE TECHNOLOGY
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
1
2
Touch test area and
Set to Auto-On ( )
look for the SafeSense
to activate SafeSense
®
indicator to illuminate
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous
operation and recovery time for this shredder.
SafeSense Indicator: If hands are too close to the paper entry, the SafeSense
®
PAPER JAM
1 2
Alternate slowly back and forth
Set to Reverse ( )
3
2
Set to Auto-On ( ) Feed paper/card
straight into paper
entry and release
3
SafeSense is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to OFF ( )
indicator will illuminate and the shredder will stop shredding.
®
3 4
Set to OFF ( )
and unplug
4
When finished shredding
set to OFF ( )
2 3
*Apply oil across entry
Set to Reverse (
for 2-3 seconds
15
5 6
Gently pull uncut paper Set to Auto-On (
and resume shredding
from paper entry. Plug in.
)
)