Advertisement
BASIC SHREddING OPERATION
PAPER OR Cd/CARd
1
2
1. Plug in and put
2. Press ( ) auto to
disconnect power
activate (green)
switch in ON (I) position
JAM PROOF SYSTEM OPERATION*
Eliminates frustrating jams by preventing overloads and powering through misfed paper.
1
2
SET-UP ANd TESTING
FPO
If too many sheets, indicator will
1
light up to red and shredder will
not take paper
2
AUTO
Feed into paper entry
and release
AUTO
Shredder will take fewer sheets,
but if indicator is below yellow,
you can add more sheets without
fear of jamming
*100% Jam Proof when used in accordance with user manual
AUTO OIL OPERATION
Automatically oils the cutters to enhance performance and extend shredder life.
SET-UP ANd TESTING
1
Before using, fill oil
To test, lift CD flap to clearly see
reservoir with 12 oz.
cutters. Then press the bulldog and
(355 ml.) of shredder oil
forward key at the same time
SAFESENSE
TECHNOLOGY OPERATION
®
Stops shredder immediately when hands are too close to the paper entry.
SET-UP ANd TESTING
1
2
Turn the shredder on to
Touch test area and
activate SafeSense
look for the SafeSense
®
indicator to illuminate
3
4
3. Feed into paper
4. Hold CD at edge,
entry and release
feed into CD entry
and release
3
Remove several sheets until the
indicator is below red and the
shredder will take the paper
3
Increase the number of sheets
being fed up to the top yellow light
to maximize your productivity
AUTO
2
Oil will spray out of the nozzles
confirming that the system is
working properly
3
SafeSense
is active and
®
working properly
®
5
6
5. Hold card at edge,
6. Set to Off ( )
feed into card entry
and release
2
AUTO CORRECTING
AUTO
Automatic correcting action will
1
power through the misfed paper,
so shredding can continue (do not
add more paper during flashing)
2
If paper is misfed and
stops shredding, all
indicator lights will
illuminate and shredder
will pause for 3-6 seconds
If there is too much paper for the
shredder to power through, it will
reverse the paper out for easy
removal
REFILLING OIL
1
Low oil indicator will
To maintain shredder performance, refill
signal when your
oil reservoir with up to 12 oz. (355 ml.)
reservoir needs refilling
of shredder oil (Fellowes #35250)
FLASHING INdICATOR
1
2
SafeSense
is deactivated when
Shift override switch to
®
indicator is flashing
the "active" position,
reactivating SafeSense
3
If Remove Paper icon (
) is
illuminated, press reverse and
remove paper
3
Reduce paper quantity to an
acceptable amount and refeed into
paper entry
2
Once refilled, automatic oiling
will resume
3
Confirm the indicator is no longer
flashing and retest by putting
your hand on the test area
®
3
Advertisement
