First Steps - Frigidaire CFC13M5AW1 Owner's Manual

First Steps
3 II
Installation
Unpacking and Leveling
DISCARD THE (4) CRATING
SCREWS AND (2) WOOD BASES
%
- Upright Freezers
ase Panel Screws
Hinge
Figure 1
_To allow door to
closeandsealproperly, DO NOT let
food packagesextendpastthe front
of shelves.
Shelf Front
Before starting the freezer, follow these important first steps:
Installation
• Choose a place that is near a grounded electrical outlet.
• For the most efficient operation, the freezer should be located where surrounding
temperatures will not exceed 1 IO°F (43°C). Temperatures of 32°F (O°C)and below
will NOT affect freezer operation. Additional compressor heaters are not recom-
mended.
• AIIow space around the unit for good air circulation. Leavea 3 inch (75 mm)space
on all sides of the freezer for adequate circulation.
Leveling
The freezer must have all bottom corners resting firmly on a solid floor, The floor must
be strong enough to support a fully loaded freezer, Check the cabinet with a levelfrom
side to side, After discarding the crating screws and wood base, level the cabinet,
To Level Upright Unit:
Once leveled, slightly raise adjustment of front feet so the door closes easily when
opened about halfway.
To Level Chest Unit:
If needed, add metal or wood shims between feet pads and floor.
Cleaning
• Wash any removable parts, the freezer interior, and exterior with mild detergent
and warm water. Wipe dry. DO NOT USE HARSH CLEANERS ON THESE
SURFACES.
• Do not userazor blades or other sharp instruments, which can scratch the appliance
surface when removing adhesive labels. Any glue left from the tape can be
removed with a mixture of warm water and mild detergent, or touch the residue
with the sticky side of tape already removed. DO NOT REMOVE THE SERIAL
PLATE.
Door Removal
(upright models)
If door must be removed to fit through narrow doorways:
1. Gently lay freezer on its back, on a throw rug or blanket.
2. Remove base panel (some models) by unscrewing two screws from front of base
panel. (Figure 1)
3. At top of cabinet, lift up plastic hinge cover and fold
back. (Figure 2)
4. Use a Phillips® screwdriver to loosen and retighten
screws on top hinge to insure a secure assembly and
prevent hinge slippage.
5. Remove top hinge from cabinet. Lift door off lower
hinge pin.
6. After door is removed, remove the two screws from
bottom hinge.
7. To replace door, reverse above order.
SCREWS
TOP _C
HINGE _ _ ,I
i HINGE COVER
UPRIGHT FREEZER DOOR ADJUSTMENTS
Figure2