Premaintenance Procedures; Raising The Seat; Greasing The Bearings; Accessing The Battery - Toro TimeCutter Z4200 Operator's Manual

Premaintenance
Procedures
Raising the Seat
Make sure the motion control levers are locked in the
park position. Lift the seat forward and lower it to the
floor board.
The following components can be accessed by raising
the seat:
• Serial plate
• Service decal
• Seat adjustment M_ob
• Fuel filter
• Fuses
• Battery cables
Lubrication
Greasing the Bearings
Service Interval: Every 25 hours--Grease all
lubrication points.
Grease Type: No. 2 General Purpose Lithium Base
Grease
1. Park the machine on a level surface and disengage
the blade control switch.
,
,
Move the motion control levers outward to the
park position, stop the engine, remove the key and
wait for all moving parts to stop before leaving the
operating position.
Clean the grease fittings (Figure 19 and Figure 20)
with a rag. Make sure to scrape any paint off of the
front of the fitting(s).
Accessing the Battery
1. Raise the seat.
2. Remove the TORX ;R_' head fasteners (25) securing
the left cover to the frame as shown in Figure 18.
2
\
\
1.
2.
b
2
J
//_ G00506!
Figure 18
Left cover 3. Battery
Torx head fasteners (25)
3. Lift the plastic cover away from the machine. Retain
all fasteners.
Replace the cover and secure it to the frame using the
fasteners removed previousl):
1. Front caster tire
J 1
G005066
Figure 19
Figure 20
Located on the seat pan underside
1. Read the instructions
before servicing or
performing maintenance.
2. Check tire pressure every
25 operating hours.
3. Grease every 25 operating
hours.
4. Engine
21