Advertisement
3
IMPORTANT!! PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE
KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1: Carefully remove tabletop and set aside until Step 3. Lay tabletop flat--do not edge. Remove
all protective materials and set parts on a flat, non-abrasive surface. Identify parts packed in
carton against the parts list. If you are missing any parts or are unsure as how to proceed
with the assembly, call our Customer Service Center at 1-800-416-3511. Do not attempt
assembly if any parts are missing or damaged.
Step 2: Attach the table leg to the table rim to by using three of the bolts and washers provided.
Guide the bolts through the holes in corner plate of the table leg, into pre-drilled holes in
the table rim as shown in the Diagram. Do not over tighten. Over tightening may strip bolts.
Repeat for the other three legs.
Step 3: With the help of another person, ture the table in the upright position. Carefully place
tabletop inside the table rim. Your table is now ready for use. If you have any questions,
please call our Customer Service Center at 1-800-416-3511.
IMPORTANT NOTE: Damage to welds or frames resulting from over tightened bolts or
imporper assembly is not covered under our warranty. Please read all instructions carefully
before assembly. If you have any questions regarding your assembly, call our Customer
Service Center at 1-800-416-3511.
4
Advertisement
