Advertisement
3
IMPORTANT!! PLEASE READ ENTIRE INSTRUCTION
SHEET BEFORE ASSEMBLY!!
TO EXPEDITE ANY FUTURE WARRANTY CLAIMS, PLEASE
KEEP INSTRUCTION SHEET, WARRANTY CARD AND RECEIPT
Step 1: Remove all protective materials and set the parts on a flat, non-abrasive
surface. Identify the parts packed in the carton against the parts list. If you
are missing any parts or are unsure as how to proceed with the assembly,
please call our Customer Service Center at 1-800-416-3511. Do not
attempt assembly if any parts are missing or damaged.
Step 2: Attach the leg connector bracket to the chair frame by using the a bolt and
washer as shown in the diagram. Guide the bolt through the hole in the leg
connector bracket, into the pre-drilled hole in the chair frame. Hand
tighten 2-3 revolutions only. Repeat for the other three sides.
Step 3: After making any necessary adjustments to the alignment of the chair frame
and leg connector bracket, use the hex bolt driver to tighten all bolts. Each
bolt must be tightened a few revolutions at a time. In order to apply equal
pressure to all bolt joints, we recommend working in a cross corner
(X fashion). Repeat until all bolts are tight. Do not over tighten. Cover all
bolts with the bolt covers provided.
Step 4: Your chair is now ready for use. If you have any questions, please call our
Customer Service Center at 1-800-416-3511.
4
Advertisement
