Grizzly T10121 Instructions

Damage to your eyes, lungs, and skin could
result from using misting unit without
protective gear, such as safety glasses,
a respirator, and rubber gloves.
Use personal protection
equipment when handling
coolants and using this
tool. follow federal, state,
coolant
requirements to properly
dispose of coolants.

Specifications

•
Distribution Tube Overall Length
•
Atomizing Tip Orifice ID
•
Construction .............Steel, Brass, Aluminum
•
Suction Tube ...................................
•
Suction Tube Filter Type
•
Air Valve Type ........................ Lever and Ball
•
Misting Valve Type
•
Fitting Type ........................ Push-On
•
Recommended Air Supply
•
Weight ...............................................3.74 lbs
If you need help with your new misting unit, call
our Tech Support at: (570) 546-9663.
WARNING: NO pORTION Of ThIS MANUAL MAy bE REpRODUCED IN ANy ShApE
OR fORM WIThOUT ThE WRITTEN AppROvAL Of GRIzzLy INDUSTRIAL, INC.

pOISON hAzARD!

manufacturer
.......... 19
......................... 2mm
⁄ " x 80"
3
32
........... Brass Wafer
............ Knob and Needle
⁄ " NPT
1
4
........... 90-120 PSI
COPyRIghT © MAy, 2009 By gRIzzLy INDuSTRIAL, INC.
#CR11822 PRINTeD IN TAIWAN.
MODEL T10121
MISTING UNIT

Operation

1.
Close the air flow and misting valves, and use
the knob to apply the magnet and clamp the
base to a metal surface (figure 1).
2. Connect the air inlet to a 90-120 PSI air
source, point the atomizing tip at the cutter,
and insert the suction tube into the coolant.
3. use the air valve and the misting valve to
control the misting spray so it can barely be
seen. Flooding is not required.
⁄ "
3
4
Misting
Valve
Suction
Tube
figure 1.
MAGNETIC
INSTRUCTIONS
Atomizing
Tip
Valve
Filter
Magnetic misting unit inventory and
controls.
Distribution
Tube
Air Inlet
Air
Magnetic
Base
Control