Chapter 2: Installation; Connecting Vhf And Uhf Antennas; Antennas With 300 Ohm Flat ]Bvin Leads - Samsung TXM3096WHF Owner's Instructions Manual

INSTALLATION
Connecting VHF and UHF Antennas
If your antenna has a set of leads that
look like this, see "Antennas with
3OO ohm Fiat 7%vin Leads," below.
If your antenna has one lead that looks
like this, see "Antennas with 75 ohm
Round Leads," oil page 2.2.
If you have two antennas, see "Separate
VHF and UHF Antennas," oil page 2.2.
Antennas with 300-ohm Flat Twin Leads
If"you are using an off air antenna (such as a roof antenna or "rabbit ears") that has
300 ohm twin fiat leads, follow the directions below.
1
Place the wires from the
twin leads under the
screws on the 300-75 ohm
aoap[o/_no[ SUpD_Ie{]_
use a screw[lrlver [o
[tg_ten file SC_W_
Plug the adaptor into the
VHF/UH[ terminal on the
bottom of the back panel.
2,1 (I{APltl iv(> ] Si\l],\i{)