Table of Contents
Advertisement
Clone PRO
TM
Operation
Receiver
to Clone
PRO r_l (LEARN)
Once
a television
has been
programmed,
connect
the DSCI
cable
from the Clone PRO _Mto the television
(.lack on back of TV). With
the television
on or off; push the Learn switch.
The "busy"
LED
will
mm
on during
the programming
cycle
and turn
off
when
finished,
ffthe
television
is on, an on-screen
display
will indicated
the process
as well.
This completes
the CBX-203
learning
process.
Clone
PRO _1 to Receiver
(TEACH)
In the Teach
mode, the Clone
PRO IMhas two ways of transmitting
the data to program the television.
IR is the easiest
and requires
no
physical
connection
between
the Clone
PRO _Mand the TV.
Wired
Clone
PRO
TM
to Receiver
(TEACH)
With AC power applied
and the television
turned
on or off; connect
the Clone
PRO _M to the television's
interface
connector
(DSCI
Port) with an appropriate
connecting
cable.
Push the Teach
switch.
The busy LED should
light indicating
the program cycle has started.
When finished
the busy LED will turn off indicating
the program
cycle is complete.
If the television
is on, an on-screen
display
will
indicated
the process
as well.
Wireless
Clone
PRO
TM
to Receiver
(TEACH)
Hold the Clone
PRO _Mapproximately
two to three feet in fi'ont of
the television.
Point
the Clone
PRO _M at the IR window
on the
front
of the TV and push
the ON switch.
Press the Teach
switch
and the busy LED
should
light indicating
the program
cycle has
started.
When
finished
the busy LED
will turn off indicating
the
program
cycle is complete.
An on-screen
display
will indicated
the
process
as well.
Clone PRO
TM
Hints
When using the Clone PRO _Min the IR mode, the Clone
PRO _j will time out after about 30 sec. if no keys are
pressed.
When
connected
to the television,
via the DSCI jack, the
Clone
PRO _Mgets it's
power
from
the TV.
There
is no
need for the battery
when
using the DSCI connection.
If the Clone
PRO IM is in the IR mode (IR ready LED is lit)
and the DSCI
is then used to connect
to the TV, the Clone
PRO
TM
will
not function
until
the IR mode
times
out.
NOTE:
The 1R read), LED wi!I go out and the green
DSC7
ready
LED
will be lit, but art), key press
on the Clone
PRO _/ and
the 1R LED
bray
will
light
indicating
the
Clone PRO 7_tis still in the 1R mode.
If the Clone
PRO _Mlocks up and no functions
seem to be
working,
the
DSCI
cable
and
the
battery
need
to be
disconnected
for 3-5 minutes
to reset the Clone
PRO _M.
Advertisement
Table of Contents
