Zanussi ZFT610W User Manual page 11

1. Remove the plug from
the power socket.
2. Tilt back the appliance
carefully so that the com-
pressor cannot touch the
floor.
3. Unscrew the adjustable
feet, situated on both sides
at the front.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
Electrical Connection
Caution! Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Warning! This appliance must be earthed.
The manufacturer declines any liability should these
safety measures not be observed.
4. Remove the lower door
hinge by unscrewing the 2
retaining screws.
5. Remove the hinge pin
from the bottom of the
door.
6. Slot the hinge pin into
the hole in the hinge plate.
7. Take the door off.
8. Refit the upper hinge pin
into the opposite location.
9. Fit the door in place on
the hinge pin.
10. Slot the hinge pin into
the hole in the hinge plate
and relocate the hinge as-
sembly to the opposite lo-
cation and refit using the
retaining screws.
11. Refit the bottom hinge
plate assembly on the op-
posite side, taking care that
the edge of the door is par-
allel with the side of the
cabinet.
1
Important! The wires in the mains lead are coloured in
accordance with the following code:
Green and Yellow:
1
Brown:
3
12. Remove and install the
1)
handle on the opposite
side.
13. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.
2
3
4
5
Earth
Live
11