Zanussi ZDE47200W User Manual page 12

point of the hose and to place a small container below it.
(See picture, point B).
Once connected to the dryer, run the vent hose to the de-
sired outlet point, ensuring that the run's overall length is
less than 2 m, and that it contains no more than two
bends. As to the outlet itself, if you have decided on a
fixed wall/window grille, a good local builder's merchant
should be able to supply you with the necessary fittings
and installation advice.
Warning!
It is important not to connect
the vent hose to, for
example, a cooker hood, or
a chimney or flue pipe
designed to carry the
exhaust from a fuel burning
appliance.
Note that to avoid condensa-
tion problems, it is essential
that the dryer be fitted with the flexible hose to carry its
"exhaust" at least beyond the kitchen units; preferable out-
side the kitchen. In order to prevent the appliance from
overheating, it is important that the steam exhaust is un-
obstructed. Therefore, in case of a permanent hose fitted
to an exterior wall or ceiling, it must be ensured an ex-
haust capacity of at least 150 m3/h. If the dryer is fitted
next to kitchen units, make sure that the vent hose is not
squashed. If the hose is partially squashed, drying effi-
ciency will be reduced, resulting in longer drying times
and higher energy consumption. If the hose is completely
squashed, the safety cut-outs with which the machine is
fitted may operate. When operating the tumble dryer, the
room temperature must not be lower than +5°C and high-
er than +35°C, as it may affect the performance of the ap-
pliance.
Electrical connection
Details on mains voltage, type of current and the fuses re-
quired should be taken from the rating plate. The rating
plate is fitted near the loading aperture (see "Product de-
scription" chapter).
Connect the machine to an earthed socket, in accordance
with current wiring regulations.
Warning! The manufacturer declines any
responsibility for damage or injury through failure
to comply with the above safety precautions.
12
Should the appliance power supply cable need to be
replaced, this must be carried out by an authorised service
engineer or a qualified electrician. .
The appliance is supplied with a 13 amp plug fitted. In the
event of having to change the fuse in the plug supplied, a
13 amp ASTA approved BS 1363/A fuse must be used.
4
1
The wires in the mains lead are coloured in accordance
with the following code:
Blue - Neutral
1
cord clamp
2
Brown - Live
3
Green and Yellow - Earth
4
The wire coloured green and yellow must be connected to
the terminal marked with the letter «E» or by the earth
symbol or coloured green and yellow.
The wire coloured blue must be connected to the terminal
«N» or coloured black.
The wire coloured brown must be connected to the termi-
nal marked «L» or coloured red.
Upon completion there must be no cut, or stray strands of
wire present and the cord clamp must be secure over the
outer sheath.
Warning! A cut off plug inserted into a 13 amp
socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Warning! The plug must be accessible after
installing the machine.
Permanent connection
In the case of permanent connection it is necessary that
you install a double pole switch between the appliance
and the electricity supply (mains), with a minimum gap of
3
2
www.zanussi.com