Table of Contents
Advertisement
SECTION 3: ASSEMBLING YOUR LAWNMOWER
Removing UnitFromCarton
•
Remove staples, break glue on top flaps or cut tape
at carton end and peel along top flap to open
carton.
•
Remove loose parts if included with unit (i.e.,
operator's manual, hardware pack etc.).
•
Cut corners and lay carton down flat. Remove
packing material.
•
Roll or slide unit out of carton. Check carton
thoroughly for loose parts.
NOTE:
Make sure
not to crimp the cables
while
removing the loose parts or the entire unit from the
carton.
ToolsRequired
•
Pair of Pliers
•
Funnel
•
Set of adjustable wrenches
Disconnecting S parkPlug
•
Before setting up your lawn mower, disconnect the
spark plug wire from the spark plug. See Figure 1.
S ark_l!
Wire
P
_!"g_.
Y
Spark Plug
Figure 1
NOTE: Reference to right or left hand side of the mower
is observed from the operating position.
IMPORTANT: This unit is shipped without gasoline or oil
in the engine. Be certain to service engine with gasoline
and oil before operating your mower.
Assembling Handle
•
For shipping purposes, the grass bag was placed
on top of the unit. Remove it from the unit and set it
out of the way. See Figure 2.
Lower Handle
Lift lower handle
\
,
Grass Bag
Upper
Handle
Figure 2
•
Raise the lower handle, as shown in Figure 2, till it
snaps into place.
•
Raise the upper handle as shown in Figure 2.
•
Tighten the two wing nuts which are already on the
handle. See Figure 3.
Upper
Handle
Tighten these
wing nuts
Lower
Handle
Figure 3
NOTE: Make sure to route the cables outside the lower
handle. Also do not crimp the cables while lifting the
handle up.
Remove the hairpin clips from the outer hole in the
weld pins on the handle mounting brackets. Using a
pair of pliers, squeeze one leg of the lower handle
against the handle mounting bracket. Insert the
hairpin clip into the inner hole on the weld pin.
Repeat on the other side. See Figure 4.
Advertisement
Table of Contents
