Download Print this page

Whirlpool LSQ8000LQ2 User Instructions page 2

Dryer cycle descriptions

Advertisement

Available languages

Available languages

'_v_ _ _
_
g_ _ __'_1_ _
ACCUDRY
TM
System
You may use your Automatic
cycle to dry most loads. Your dryer
uses the electronic ACCUDRY
TM
system. The control senses the
moisture level in the load and shuts off when the load reaches the
selected dryness. Your easy-to-use dryer has a color-coordinated
Cycle Control knob and Temperature selector.
Your dryer has 5 automatic cycles and 3 corresponding
temperature selections.
When using the Automatic
cycles, you may simply choose the
setting on the Cycle Control knob that corresponds with the
one you choose on the Temperature selector.
The cycle control knob does not move until the load is almost dry.
After the Cool Down, the knob automatically turns to an Off area
and tumbling stops.
At the end of the cycle, check the dryness of the load.
If the load is drier than you like, you may select a setting closer
to Less Dry the next time you dry a similar load.
If a load is not as dry as you like, you may complete drying
using a Timed cycle. You may select a setting closer to Very
Dry the next time you dry a similar load.
NOTE: Drying time with an automatic cycle varies according to
the type of fabric, size of load, and temperature setting.
WRINKLE
SHIELD
TM
Plus Setting
You may choose 30 or 90 minutes of periodic unheated tumbling
after the cycle ends.
NOTE: A signal will sound periodically when the WRINKLE
SHIELD
TM
setting is selected, but only if the End of Cycle signal is
also selected.
TIMED
DRYING
These cycles may be used to complete drying if items are still
damp after the automatic cycle.
Timed Drying is also useful for:
Heavyweight or bulky items that require a longer drying time.
Lightweight items that require a short drying time.
NOTE: You may choose a setting based on the fabrics in your
load. Drying time and temperature will depend on your dryer
model.
You may select a drying temperature based on the fabrics in your
load. If you are unsure of the temperature to select for a load, you
may select the lower setting rather than the higher setting.
Temperature Tips
A high heat setting may be used for drying heavyweight items
such as towels and work clothes.
A low to medium heat setting may be used for drying medium-
weight items such as sheets, blouses, dresses, underwear,
permanent press fabrics, and some knits.
A low heat setting may be used for drying lightweight items
such as lingerie.
You may use a no heat (air) setting for rubber, plastic or heat-
sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions.
The End of Cycle Signal sounds when a cycle is complete. The
End of Cycle Signal is selectable and the signal will sound only if
set to On.
If the WRINKLE SHIELD
TM
Plus feature is selected and the End of
Cycle Signal is on, the signal sounds every few minutes. The
signal stops when you open the door or turn the Cycle Control
knob to Off.
The drying rack is useful for machine drying items you would not
necessarily want to tumble dry or that you would normally line dry
(for example, pillows, stuffed toys).
For ordering information,
please refer to the service numbers
located on the front page of the dryer user instructions
or contact
the dealer from whom you purchased your dryer.
DRYEL _ fabric care system
When using DRYEL _ fabric care, you may select the DRYEL _ cycle
setting and the DRYEL ®temperature setting. DRYEL _ fabric care,
when used in accordance with the manufacturer's directions, has
been tested and approved for use in full-size dryers built by
Whirlpool Corporation.

Advertisement

loading