Electronicovencontrol; Display; Start; Off/Cancel - Whirlpool GMC275 Use & Care Manual

A B
/qg÷
BAKE
TEMR
CUSTOM
BROIL
©©©
COOK DELAY STOP
TIME TIME TIME
M
ELECTRONICOVENCONTROL
C D
©©
OVEN AUTO
LIGHT CLEAN
¢¢UBA_E
E
NOUN MIN
,, o/B,N
'N / _.E_
N Z
L K J H G
F
/
GGG ©
@Cbq
Ab,O
¢OOR
GGG
POPCORN BEVERAGE BAKED WARM
(3 SIZES) POTATO HOLD
G@©©©
OFF/CANCEL
MICRO QUANTITY COON MEMORY cooka k_._ _
TIME ROWER bit more
MICROWAVE OVEN
A. Oven setting pads
B. Temperature pads
C. Oven light
D. Auto clean
E. Electronic display
K Microwave oven controls
G. Lower oven off/cancel
H. Start pad
I. Clock pad
J. Timer set and off
K. Minute pad
L. Hour pad
M. Electronic clock control
When power is first supplied to the appliance, "PF" will appear on
the display. Press LOWER OFF/CANCEL to clear.
If "PF" appears at any other time, a power failure has occurred.
Press LOWER OFF/CANCEL and reset the Clock if needed.
When the oven is in use, the display shows preheat time and the
temperature and oven setting.
When the oven is not in use, the display shows the time of day.
When using Cook Time (on some models), the display will show
either hours and minutes, or minutes and seconds.
The Start pad begins any oven function except the Timer. If the
Start pad is not pressed within 5 seconds after pressing a
function pad, the "Start?" indicator light will flash as a reminder.
On some models, "START?" will appear on the display.
If the Start pad is not pressed within 4 to 5 minutes (depending
on your model) after pressing a function pad, the oven display will
return to the time of day mode and the programmed function will
be canceled.
The Off/Cancel pad stops any function except the Clock, Timer
and Control Lock.
The cooling fan may continue to operate after an oven function
has been canceled, depending on oven temperature.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
Before setting, make sure the oven, Timer and Timed Cooking
are off.
1. Press CLOCK.
2. Press the HOUR or MIN "plus" (+) or "minus" (-) keypads to
set the time of day.
3. Press CLOCK or START.
To Disable:
The clock time can be disabled so that it does not show on the
display. To disable, press and hold CLOCK for 5 seconds. To
display the clock time again, press and hold CLOCK for
5 seconds and the time of day will show on the display. The clock
time should not have to be reset.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheated
• Function has been entered
Three tones
• Invalid pad press
Four tones
• End of cycle
• Reminder, repeating each minute after the end-of-cycle tones