Table of Contents
Advertisement
PROGRAMMI
NG THE REMOTE
The universal remote can be programmed
to control
most brands of
remote controllable
VCRs, satellite
receivers and cable boxes. The
remote is already programmed
to control
most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellite
receivers.
TESTING
THE REMOTE
To determine
whether
the universal
remote needs to be programmed,
turn a device ON, such as a VCR, point the remote at the VCR, and press
the VCR1 button.
Then press POWER or CH ^ (channel up) or CH v
(channel down) to see if the VCR responds to the remote commands.
If
not, the remote needs to be programmed.
USI NG AUTOMATIC
CODE SEARCH
The following
instructions
can be used to program
the remote to
control
each of the devices connected
to your TV. If you want to exit the
automatic
code search without
programming
any of your devices, press
CLEAR until the LED turns off.
1.
2.
3.
Turn on the device you want to control
(VCR, SAT, etc.)
Point the remote at the device to be controlled.
Press and hold the
button
you want to program
(VCR1, VCR2, etc.). While holding
the
device button,
press and hold ON.OFF until the red light on the
remote turns on, then release both buttons.
For the AUX button,
using code search will not work. You must use direct entry.
Press and release PLAY, then wait 5 seconds or until the LED stops
flashing.
At this point the remote is searching for the correct code to
program.
If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue
pressing PLAY until the device turns off or you have
searched through
all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control
that particular
device.
If the device you want to control
doesturn
off:
1.
Press and release REVERSE,then wait 2 seconds. Repeat this step
until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
LED
You'll use these buttons when you program
the remote
to control any device.
The remote
may not operate
all models of
all brands.
Using Direct Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the
code list on the last page of this section, Using the Remote.
24
Advertisement
Table of Contents
