Related Manuals for Faber Remote Blower
Summary of Contents for Faber Remote Blower
- Page 1 Concept Remote Blower READ AND SAVE THESE INSTRUCTIONS The Installer must leave these instructions with the homeowner. The homeowner must keep these instructions for future reference and for local electrical inspectors’ use. Instruction Manual...
-
Page 2: Table Of Contents
CONTENTS WARNING CHARACTERISTICS INSTALLATION MAINTENANCE... -
Page 3: Warning
3. The fire department is being called. 4. You can fight the fire with your back to an exit. CAUTION: To Reduce The Risk Of Fire And Electric Shock, Install This RangeHood Only With Remote Blower Models Rated Maximum. 4,2 A suitable for use with solid stade speed controls. - Page 4 This appliance should be connected directly to the fused disconnect (or circuit breaker) through flexible, armored or nonmetallic sheathed copper cable. Allow some slack in the cable so the appliance can be moved if servicing is ever necessary. A UL Listed, 1/2" conduit connector must be provided at each end of the power supply cable (at the appliance and at the junction box).
-
Page 5: Characteristics
CHARACTERISTICS Components Q.ty Hood Body, complete with: Blower, Filters, Controls Built-in hood body case Rear remote motor connection panel Top air outlet flange with valve Top air outlet plug Light Support arms Bush masking plug Arm support bush Screws 3,5 x 16 Screws 5 x 70 Wall Plugs ø... - Page 6 Dimensional chart - Hood...
- Page 7 Dimensional chart - LIGHT...
-
Page 8: Installation
Do not install two elbows together. Round duct is recommended instead of rectangular duct especially if elbows are needed. For internal blower models, rectangular duct should be transitioned to 9" round as soon as possible. - Page 9 LIGHTING UNIT LOWER BORDER SHALL BE INSTALLED AT THE MINIMUM DISTANCE OF 34 9/16 IN. ABOVE THE COOKING SURFACE. With the aid of the drilling template provided mark the necessary holes and drill them. The hood is manufactured with the air outlet at the top. •...
- Page 10 • Remove the suction panel by unfastening the 8 screws around the frame. • Remove the metal grease filters. • Remove the metal profile fixed to the flange by unfastening the 5 screws. • Fit the air outlet plug into the top air outlet. •...
- Page 11 • In case of the bottom air outlet configuration the hood body has to be turned 180°. • Remove the top cover of the terminal box by unfastening the two screws fixing it to the hood casing. • With the aid of pliers brake through a hole inside the terminal box providing thus for a passage of the electrical connection for the lighting unit.
- Page 12 • Provide for passage of the electrical connection wires with the hood body. • Slide the top cover downwards, unfastening the two side screws and taking care not to scratch the tubular support members. • Insert the 4 plugs D into the earlier drilled holes. •...
-
Page 13: Electrical Connection
• Connect the blue blower wire with the blue lead in the hood using a twist- on connector; connect the brown blower wire with the brown lead in the hood using a twist-on connector. -
Page 14: Use
The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button. 0/1 Light Turns lighting on and off. 0/1 Motor Fixed First speed. When pressed for about 2 seconds the motor is switched off. Speed Fixed Second speed. - Page 15 Lighting LIGHT REPLACEMENT 20 W halogen light. • Extract the lamp from the Support. • Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. Electric Diagram...
- Page 16 436002499_02 - 041103...