Programming The Remote; Testing The Remote; Using Automatic Code Search - RCA PTK195 User Manual

PROGRAMMING THE REMOTE
The universal remote can be programmed to control most brands of
remote controllable VCRs, satellite receivers and cable boxes. The
remote is already programmed to control most RCA, GE and PROSCAN
TVs, VCRs, DVD players, laserdisc players and satellite receivers.
TESTING THE REMOTE
To determine whether the universal remote needs to be programmed,
turn a device ON, such as a VCR, point the remote at the VCR, and press
the VCR1 button, Then press POWER or CH ^ (channel up) or CH v
(channel down) to see if the VCR responds to the remote commands. If
not, the remote needs to be programmed.
USI NG AUTOMATIC CODE SEARCH
The following instructions can be used to program the remote to
control each of the devices connected to your TV. If you want to exit the
automatic code search without programming any of your devices, press
CLEAR until the LED turns off.
1.
2.
3,
Turn on the device you want to control (VCR, SAT, etc.)
Point the remote at the device to be controlled, Press and hold the
button you want to program (VCR1, VCR2, etc.). While holding the
device button, press and hold ONoOFF until the red light on the
remote turns on, then release both buttons. For the AUX button,
using code search will not work, you must use direct entry.
Press and release PLAY, then wait 5 seconds or until the LED stops
flashing.
At this point the remote is searching for the correct code to
program. If, after 5 seconds, the device you want to control does
not turn off, press PLAY again to tell the remote to search the next
set of codes.
Continue pressing PLAY until the device turns off or you have
searched through all of the codes. There are 20 total sets of codes.
If the device does not turn off after pressing PLAY 20 times, then
the remote cannot control that particular device.
If the device you want to control does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat this step
until the device turns back ON.
2. To finish, press and hold STOP until the red light on the remote
turns off,
LED
You'll use these buttons when you program
the remote to control any device.
The remote may not operate all models of
all brands.
24