Table of Contents
Advertisement
Using the Remote Controi
Using Automatic Code Search
The following
instructions
can be used to program the remote to operate each of
your components,
if you want to stop the automatic
code search without
programming
any of your components,
press CLEAR until the indicator
on the
remote turns off.
1, Turn on the component
you want to operate {VCR or DVD player}
2,
Press and hold the component
button
you want to program (VCR or DVD}.
While holding the component
button,
press and hold ON.OFF until the
indicator
on the remote turns on, then release both buttons,
3
Point the remote at the component.
Press and release PLAY, then wait S
seconds or until the indicator
on the remote stops flashing,
At this point the remote is searching for the correct code to program. If, after 5
seconds, the component
you want to operate does not turn off, press PLAY
again to tell the remote to search the next set of codes,
Continue pressing PLAY until the component
turns off or you have searched
through all of the codes, There arc 20 total sets of codes, If the component
does not turn off after pressing PLAY 20 times, then the remote can't be
programmed
to operate that component,
If the component
you want to operate does turn off:
1
Press and release REVERSE,then wait 2 seconds, Repeat this step until the
device turns back ON,
2, To finish, press and hold STOP until the indicator
on the remote turns off
Using Direct Entry
1
Turn on the component
to be programmed.
2,
Look up the brand and code number(s} for the component
on the code list in
this section,
3,
Press and hold the component
button
you want to program on the remote.
4
Enter the code from the remote control code list on the following
pages, If the
indicator
flashes, you have either entered an invalid code or the button
isn't
programmable.
5
Release the component
button,
6,
Point the remote at the component.
Press ON.OFF to see if the component
responds to the command
If it doesn't, try pressing the component
button
and
then ON.OFF again,
•
If you get no response, repeat these steps using the next code listed for your
brand, until the component
responds to the remote commands,
•
If you try all the codes for your component
brand and none work, trythe
automatic
code search method, If automatic
code search doesn't find the code,
the remote is not compatible
with your component,
1 0
Graphics contained
within this publication
are for representation
onl_
Chapter
2
Advertisement
Table of Contents
