Table of Contents
Advertisement
PIP Problems?
•
Make sure the remote is in the right mode.
For example, once you
turn on the VCR with the VCR1 button,
you can't SWAP the pictures
until you put the remote in TV mode. Just press the TV button.
No signal or bad reception?
Most VCRs and satelEte receivers have
an antenna
or TV button.
If your cable or off-air antenna
goes into
your VCR or satellite receiver, then into your TV, try pressing the
antenna or TV button
on the front of the component.
Tip: If programmed
to control your VCR, the ANTENNA button
on
the remote acts as a TV/VCR button.
Check the connections.
PIP requires a second video source, like a
VCR or satellite
receiver, connected to your TV with audio/video
cables. If you use a cable box, you may need extra equipment.
Contact your cable company for more information.
CABLE,
CABLE
BOX,
OR ANTENNA
TV
To see a different picture in the PIP
window, you must connect another
video
source, like a VCR. This connection
requires audio/video
cables.
37
Advertisement
Table of Contents
