Table of Contents
Advertisement
•
Z
.
Highlight the channd
to which you have to tune your "1_, ,_in order to see
caUle programming,
and press OK (a screen appears reminding
you to
connect
your G-LIN_ cM._leto your "1% _ and cable box).
Notes:
Chanmq
03 is the most common.
C_*oose Vi&_ tiA UX if your cable b(_v ia conw_cted to f!_ur TV u ith
a_ldioi_qde_ c_hles instead q[a co(_ial cable. Go Io jmge 7fi_rpiclure_' q[
Ihe_e cd_hles.
Igor more irt/brmation,
go Io cahle box connection
on page t2.
4.
Highlight your brand of cable bo×, and press OK.
If your brand isnt Iisted, highlight
Not Listed and press OK.
.
Make sure your cable box is on.
Tune the cable bo× to channel 02 (use the remote control that came with
your cable bo×, or press the channel buttons on the cable box).
Press OK (the GUIDE Plus+ system starts testing coded).
Important
Note: where code testing ia in p*_gres_ don't Iouch you*" 7_ _,
_CR_ cable box or any of'lhe remoR¢ contro[s.jbr Ihe_e products.
.
Look at your cable box. If it is stiIl on and changed to channel 09, the test
was successfl.fl. HighIight }_s_ and press OK (S7E'P3: Configu*{ngfi_ra
VCR
If your cable box didn't change to channel 09 or turned itself off; you have
_o
choices: No and T_t Ihis code agairL
T*_t Ihis code again: If you think the TV, the cable box, or any of the
remote controls might have been touched
or bumped
during tim test,
highlight
Test lhis code agair_ and press OK ((the GUIDF. Plus+ system runs
the same set of coded),
No: 1[" you don't think the test wins interrupted,
highlight
No and press OK
(GUIDE Plus+ system tests the next code).
Repeat the previous instm(_ions
until the 'W finds the correct cable box
code. Follow the instructions
on the screen.
Note:
Tlhe TV can't find 3Dur cahle _x)x co&< a trouhleshooting
&ecblist alg_a*_. Ca*zfidl y rc_%az_ each che_cbl_t and fi_[low Ibe
irtst*v¢ctio_ oft
lhe
Scre_gt,
Advertisement
Table of Contents
Troubleshooting
