Table of Contents
Advertisement
PROGRAMMING
THE REMOTE
Using Automatic
Code Search
The following
instructions
can be used to program
the remote to control
each of the devices connected
to your monitor.
If you want to exit the
automatic
code search without
programming
any of your devices, press
and hold CLEAR until the LED turns off.
1,
2.
3,
Turn on the device you want to control
(VCR, digital satellite
receiver, etc.).
Press and hold the button
you want to program
(VCR1, DIRECTV,
etc.). While holding the device button,
press and hold ONoOFF until
the red light on the remote turns on, then release both buttons.
Point the remote at the device, press and release PLAY, then wait 5
seconds or until the LED stops flashing.
At this point the remote is searching for the correct code to
program,
if, after 5 seconds or until the LED stops flashing, the
device you want to control
does not turn off, press PLAY again to
tell the remote to search the next set of codes.
Continue
pressing PLAY until the device turns off or you have
searched through
all of the codes. There are 20 total sets of codes. If
the device does not turn off after pressing PLAY 20 times, then the
remote cannot control that particular
device.
If the device you want to control
doesturn
off:
1.
Press and release REVERSE,then wait 2 seconds. Repeat this step
until the device turns back ON.
2.
To finish, press and hold STOP until the red light on the remote
turns off.
Using Direct Entry
1.
Turn on the component
to be programmed.
2.
Look up the brand and code number(s)
for the component
on the
code list on the last page of this section.
3.
Press and hold the button
on the remote you want to program.
4.
Enter the code from the code list.
S,
6,
Release button,
and then press ONaOFF to see if the component
responds to the remote commands.
If it doesn't, try pressing the
component
button
and then ONoOFF again.
If you get no response, repeat these steps using the next code listed
for your brand, until the component
responds to the remote
commands.
J
vc_2
Aux _lR_c_v
LEE)
&i & &
You'll use these buttons
when you
program the remote,
The remote may not operate all models
of all brands,
30
Advertisement
Table of Contents
