Montgomery Ward TMO-3395309 Operating Manual page 11

If the full range of speeds cannot be obtained on your
unit, adjust the speed control as follows.
1. Adjust the speed control lever by pushing the
clutch-brake pedal forward until the stop on the
brake rod is against the frame. See figure t3.
Have another person hold the pedal in this posi-
tion as you make the following adjustment. Place
the speed control lever in parking brake position.
Remove the hairpin clip and flat washer, and
adjust the ferrule on the rod so it is against the
back end of the slot. See figure 13. Then length-
en rod one more turn. Reassemble and secure
with theflat washer and hairpin clip.
2. Adjust the speed control link as follows to obtain
the correct neutral adjustment.
A. Start the engine.
B. Place the shift lever in Neutral position.
C. Place the speed control lever in high speed
position.
D. Release the clutch-brake pedal completely, then
slowly depress the pedal all the way (to park
position). Hold the pedal in this position.
E. Turn the engine off.
F. After engine stops completely, release the
clutch-brake pedal.
G. Place speed control lever in second position.
H_ Remove the cotter pin and flat washer which
secures the speed control link to the variable
speed torque bracket assembly.
I. Push the clutch-brake pedal backward by hand
as far as it will go using light pressure. Hold it in
this position as you thread the speed control link
in or out of the ferrule until it lines up with the pin
on the variable speed torque bracket assembly.
J. Secure speed control link to variable speed
torque bracket assembly with flat washer and
cotter pin.
Variable Speed
Torque Bracket
"_-._ Assembly
Speed Cotter Pin and
Control Flat Washer
Brake
Rod
Speed
Link
Ferrule
FIGURE 13.
11