Philips 37PFL5332D User Manual page 8

ilFirst time instanation
Note: The first time (and only the _rst time) you turn on your set you see an installation introduction screen, The Installation procedure consists of a
series of screens that guide you through the process.
O After an introduction screen, you are asked to select a language of the TV's on-screen menus. (The text of the header and the info on screen
continuously change language.)
0 Press the cursor up/down to highlight your language.
0 Press the OK button,
O Follow the on-screen instructions to proceed.
Part 1: TV installation
(Please skip this section if you have no cable connected to the Antenna input of the TV.)
Note - The "iV will take approximately 10-15 seconds to start up.
O Select the desired Language and press the green button "Next",
O Select Cable or Antenna in the Installation mode and press the green button "Next",
Auto Installation may take 20 to 40 minutes depending on the number of channels that are transmitted by the cable provider or
broadcaster.
O When the TV is not receiving any signal from the antenna/cable, the message CHANNEL NOT AVAILABLE will appear on the TV
screen, When no transmission is received from the broadcaster, a BLANK SCREEN will appear on the TV screen.
Note - The TV will go on to standby after 10 minutes, Press the POWER button on the remote control to on the TV.
Q You will not be able to receive pay channels when using direct antenna/cable connection to the television.
Q When the Set-top box is connected to the television using coaxial cable, it is necessary to auto-program the television for the single channel
(3 or 4) that the Set-top box outputs and change the channels at the Set-top Box (using the set-top remote control) to view the program.
Refer to the manual for more details.
Note - The newly installed channels maybe sorted in a different sequence on this TV. Please key using the CH ÷/- buttons to get to know the
new channel. Also you can use the OK key to see the list of channels,
O When the Set-top box is connected to the television using one of the AV connections (AV 1/AV 2/HDMI 1/HDMI 2), select that input
source (using the Source button) to view the programs and change the channels at the Set-top Box (using the set-top box remote control) to
view the program.
Part 2: Settings assistant
By means of several split screens/full screens you are prompted to select your preferred picture and sound settings, to finally arrive at a complete
setting which satisfies you,
O Press the green color button on your remote control to enter the Settings assistant menu,
O Select your Location with the cursor up/down and press the green color button,
If you choose Shop it will skip the Settings assistant. The TV parameters for Picture and Sound will then be set to predefined fixed settings.
Press the green color button again to proceed.
If you choose Home it will display the Settings assistant.
O Use the cursor left/right to each time select your preferred screen.
O Press the green color button to each time confirm your selection and to jump to the following screen.
The following items will be presented sequentially. In the header it is mentioned how many screens have been completed and how many
screens there are in to_aL The Settings assistant will step sequentially through the following settings: Picture and Sound,
Q Press the green color button once to store all the settings and to return to the TV installation menu.
Note: When you skip or stop the Settings Assistant, then the Standar_l settings
Philips selected for you will be chosen.
O Press the red color button to finish the First time insr_llation procedure and to display the first stored TV channel,