Philips 32PFL7332D/37 User Manual page 9

CABLE
.-e
7 g a"rL
-IF
BLE 7srz
-lr-
l OUTPUT
IN OUT
Set-Top Box
Set-Top _ox
O
Basic connections to the TV
Your integrated digital TV automatically decodes and displays the four basic DTV
picture resolution standards.
- SDTV (Standard Definition TV) are broadcast as 480i (480-line interlaced) or
480p (480dine progressive scan) video.
- HDTV (High-Definition TV) are broadcast either in the 1080i or 720p formats,
always with a widescreen picture.
Note: Progressive scan video (p) is more like that you see in a movie theaten Images are
much morn distinct and free of flicker, and motion is smoothen
Next to analog NTSC broadcast reception, your TV has an integrated High
Definition TV tuner which receives, decodes and displays terrestrial ATSC and
unscrambled cable (QAM) signals.
HDTV quality is only reproduced when a broadcaster or cable provider broadcasts
HDTV signals.
There are 2 ways to get HDTV content:
- via cable,
- via antenna.
Note; This drawing is used wherever you can connect cable or antenna.
- Cable TV
Connect the cable TV signal to the CABLE/ANTENNA
"/5 ll'=lr= jack at the bottom
of the TV. See page 18 for details on using Autoprogram to store channels in the
TV's memory.
Note: this connection will supply stereo sound to the TV if it is being broadcast by the
station you are_watching,
- Cable box with RF IN/OUT
" Connect the incoming cable TV signal to the cable IN jack C) on the back of
the cable box.
. Connect a coaxial cable (not supplied) from the TO TV jack on the back of the
cable box to the CABLE/ANTENNA 75 n-r jack (_) at the bottom of the TV.
Note: Your cable box may have a different label _or the TO TV jack, such as
OUTPUT
or OUT
" Set the OUTPUT CH switch (_) of the cable box to CH 3 or 4 (whichever is
correct for your cable box), then tune the TV to the corresponding channel.
Once tuned, change channels at the cable box, not the TV.
Note: This connection w#l not supply stereo sound to the TK The reason is that the RF
output on a cable box _ labeled TO TV, OUT or OUTPUT for exampb _ will not send a
stereo signal to the tuner (VHF/UHF) input on a TK
= Cable box with AIM outputs
• Connect the incoming cable TV signal (_ to a signal splitter (not supplied).
The signal splitter enables you to avoid having to use the TO TV jack on the
back of the cable box. This jack will not supply stereo sound to the TV.
Note: Your cobb box may have a different label for the TO TV jack, such as
OUTPUT or OUT
" Connect a coaxial cable (not supplied) to a connector on the signal splitter and
to the CABLE/ANTENNA 75 n=l_ jack (_) on the TV.
. Connect another coaxial cable (not supplied) to a connector on the signal
splitter and to the cable IN jack C) on the back of the cable box.
• Connect A/V cables (not supplied) to the VIDEO and AUDIO L and R outputs
on the back of the cable box and to the AV2 video (labeled VIDEO) and
AUDIO (labeled L and R) jacks (_ on the back of the TV.
• To view programs from your cable box, first press the SOURCE button on the
remote control
• Pressthe cursor down or up buttons until the AV2 signal source isselecte&
• Pressthe OK button to confirm your selection. The AV2 inputsource
becomes currentfor the viewing ofcable TV programs through your cable box.
Note; ff your cable box Audio/VMeo outputs will not supply wdeo and stereo au@o to
the T_4you will need to make the connection shown above in the exampb "Cable box
with RF INIOUT".