LG MU-42PZ90XC Owner's Manual page 12

Installadon
How to connect
1. Connect the provided BNC-RCA adapter to the monitor's
VIDEO INPUT.
2 Connect the audio and video cables from the external
equipment's output jacks to the monitor input jacks, as
shown in the figure. When connecting the monitor to exter-
nal equipment, match the jack co_ors (Video = yellow, Audio
Left = white, and Audio Right = red).
How to use
1. Use the INPUT SELECT button on the remote control to
select Video.
2, Operate the corresponding external equipment, Refer to
external equipment operating guide,
Carnc_
Video ga
DVD
How to connect
1. Connect the DVD video outputs to the COMPONENT (Y, PB, F
INPUT jacks and connect the DVD audio outputs to the AUDIC
INPUT jacks on the monitor, as shown in the figure.
2. If your DVD only has an S-Video output jack, connect this to t_
S-VIDEO input on the monitor and connect the DVD audio outi
to the AUDIO INPUT jacks, as shown in the figure.
How to use
1. Tum on the DVD player, insert a DVD.
2_ Use the INPUT SELECT button on the remote control to selec
Component (if connected to S-VIDEO, select the S-Video ex
hal input source,)
3. Refer to the DVD playeCs manual for operating instructions.
• Component Input ports
To get better picture quality, connect a DVD ptayer to the coml
nent input ports as shown below.
Component ports of the
Monitor
Video output ports
of DVD player
- To watch digitally broadcast programs, purchase and
connect a digital set4op box_
= This monitor supports HDCP (High-bandwidth Digital
Contents Protection) protocol for DTV
(480p,720p,1080i) modes
How to connect
1. Use the monitor's COMPONENT (Y, Pc, PR) INPUT,
RGB or DVt jack for video connections, depending on
your set4op box connector, Then, make the corre -
sponding audio connections,
How to use
1. Turn on the digital sebtop box. (Refer to the owner's
manual for the digital set4op box)
2. Use INPUT SELECT on the remote control to select
Component, RGB or DVI,
oooooo O@eoi °.